Part Number: DAC9881 Hi team,
My customer found sometimes output voltage is not correct after power-on. I have checked the power up sequence and RSTSEL &USB/BTC setting. No suspect was found. I would like to know if anything else I could take a look…
Part Number: DAC9881 I would like to ask the literature about the feedback resistor.It is unclear. Is RFB an internal resistor?On page 26,Note(1) says RFB can be 1kOhm or 2kOhm depending on the gain.that's handled internally depending on a register setting…
Hello, Any progress on this thread?
As far as solving the issue near the negative rail, depending on how things are actually implemented in your design now, one possibility is to connect the device AGND and DGND pins to a negative voltage, up to -200mV…
Part Number: DAC9881EVM-PDK Other Parts Discussed in Thread: DXP , DAC9881 , DAC8881 Unable to use the DXP GUI both on Windows 10 and Windows XP
Two Errors on Windows XP :
1. Error 1073807343 VISA Find Resource in DXP_Main.vi. State - Load Firmware…
Hi Uttam, Thank you reply, I check my hrdware again, I consider my DAC9881 board VREFH-F and VREFH-S . I Refer SPEC 1. www.ti.com/.../dac9881.pdf 2. www.ti.com/.../slau279a.pdf I would be these two pins connect together without OPA(High Precision Dual…
Part Number: DAC9881 Hello,
I understand that Power-Supply Sequence is AVDD ⇒ IOVDD,reference.
But my customer power on AVDD, IOVDD and reference at the same time, and it is performed the hardware reset(17pin /RST) after that. Are there any problems…
Part Number: DAC9881 Other Parts Discussed in Thread: INA819 Hi team,
My customer is looking at the DAC9881 to drive the REF pin of the INA819.
They would like to know if the On-Chip output buffer would be able to drive this pin.
For this, they…
Part Number: DAC9881 Hi TI team,
We are using DAC9881 for generation voltage as per the requirement .
Generate below voltages by setting DAC count 1 time
1. Generated Voltage 1 using DAC - 2.270 approximately
2. Generated Voltage 2 using DAC …
