Part Number: DCP022415D Tool/software: I am trying to use this component to create a +/- 60 V supply for the op-amps in my test device.
In principle, is that possible, i.e. to connect four voltage modules in series to achieve the desired output voltage…
Part Number: DCP022415D
I am trying to use this component to supply +\-15V for op-amps as part of a university project. My lab partner designed a PCB which uses this component. When we tested it we found the following:
Under no-load conditions, the output…
Part Number: DCP022415D Hi team
Could you tell the unit of load regulation that is described in the datasheet, P.3 Device Comparison Table?
Then, I can't understand the relation between the load regulation at P.3 and Figure 6-28?
Regards,
Noriyuki…
Part Number: DCP022415D Other Parts Discussed in Thread: ISO124 Hello team,
My customer is looking for higher isolation voltage updated product of DCP022415D.
Can you please give me suggestion?
Requirement is VIN=24Vdc, Vout=+/-15Vdc, Pout=2W (1W can…
Part Number: DCP022415D Hi team
Device Comparison Table on the datasheet P.3 mentions that the output is ranging from ±14.25V to ±15.75V at 75% load.
Are there any data of output voltage accuracy at 10% load & 100% load?
Regards,
Noriyuki…
Part Number: DCP022415D Is there any recommendations to tie the +15 and -15V lines together to acquire a ~ +30V output from this module? If so, please advise. Input Voltage: Nominal 24V (18-36)
Output Voltage Required: ~30V
Output Power: ~1W
Thank you…
Part Number: DCP022415D Other Parts Discussed in Thread: DCP021212 Hi Sir
May we have isolate power like DCP022415D but we need Vout need 24V?(my customer use in digital I/O)
Bogey
Part Number: DCP022415D Hello,
I think DCP022415D can be used in no load condition but the output voltage will be increased because unregulated.
Approximately how much voltage increased we should expected from typ 15V?
Best regards,
Toshihiro Watanabe …
Part Number: DCP022415D hi sir
I apply the DCP022415DP For test
i apply the 24v in pin1,pin2, monitor the pin 5 by ground, monitor the pin 6 by meter
i found the output voltage is not correct, i also add the cap in the in/output side
according to the…
Part Number: DCP022415D This component is rated for continuous 60 volt DC isolation use which appears to be largely due to safety considerations. For this version of the part the nominal input is 24 volts with +/- 15 volt outputs referenced to the output…
