Because of the Thanksgiving holiday in the U.S., TI E2E™ design support forum responses may be delayed from November 25 through December 2. Thank you for your patience.
Part Number: DRV8353RS-EVM Other Parts Discussed in Thread: DRV8353 Tool/software: Hi team,
1) We purchased the DRV8353RS EVM package along with the ISO-F28027F(which came along with the package). Initially I have done changes in the IS0-F28027F to work…
Hi,
For speed loop tuning, you can refer to the content in Lab is07 in the InstaSPIN User's Guide. You can access through the attached link. You can use the GUI to tune the speed loop parameters.
/cfs-file/__key/communityserver-discussions-components…
Part Number: MMWCAS-DSP-EVM I am seeing a build error when building the dra7xx-evm
many warnings, but an error specifically on iso-codes-4.1-r0:
[PSDKLA]> [PSDKLA]> Current Directory is /home/wcram/ti-processor-sdk-linux-automotive-dra7xx-evm-6.00…
JESINTHA E said: 1) We would like to know how to set the speed reference of the motor using gMotorVars.SpeedRef_krpm, Where to assign the value and in which file of the project?
You can assign a value to gMotorVars.SpeedRef_krpm in background loop as below…
Thank you Yanming for your immediate responses. This solved our issue. We used GPIO 28 for the external switch and could able to control the motor using the switch.
Part Number: DRV8353RH-EVM Other Parts Discussed in Thread: DRV8353 , DRV8353RS-EVM , MOTORWARE Hello Guys,
Good day.
User guide stated that the DRV8353Rx-EVMs are designed to be evaluated only with the ISO- F28027F MCU PCB accompanying the kit.The question…
Part Number: LMG1210EVM-012 Tool/software: Hi, I found out that the C-boot is not charging up to 5V at every switching cycle. I'm attaching the scope traces of the HB-HS w.r.t other signals. The board was supplied with only Vin = 12V drawing about…
Part Number: DRV8353RS-EVM Other Parts Discussed in Thread: DRV8353R , DRV8353 , , MOTORWARE
Hi,
There is the description on EVM user's guide shown below:
Questions:
-What's the default firmware version on EVM? Sensored firmware or sensorless? Does…
Asha Bhandarkar said: Please check if this is a pathing issue, and report back if that fixes issues.
I have cleared flatbuffer issue.
The make command got executed successfully, but while executing make tidl TARGET_PLATFORM=PC command facing the error…
Part Number: ISO5851 I want to use ISO 5851 EVM to control 10 MOSFETs (Infineon IRFB3077PbF) in serie, using TTL signal as an inpu to "ISO 5851 EVM". Should I simplyMy question is how should I do that?
If you look at manual here " datasheet…
