Hello Will,
We don't have a code example for the MSP-EXP430F5529LP and the DLP-RF430BP. The reason being is that the code required to run the DLP-RF430BP is very minimal and an MCU like the F5529 is absolute overkill for it. The code for the MSP-EXP430G2ET…
Hello AL,
for your application we would recommend using the RF430CL330H.
You will find an application note, which describes the wakeup of an external processor, here:
http://www.ti.com/lit/an/sloa200/sloa200.pdf
For tests we have also a booster…
Hello Jan, The DLP-7970ABP and DLP-RF430BP kits have gone through testing for EU compliance and passed all testing, but we are still finalizing documentation on their EU compliance to publicly released the DoC's.
Edit: I should add that the RF430FRL152HEVM…
Other Parts Discussed in Thread: DLP-RF430BP , RF430CL330H , RF430CL331H , NFC-DATALOGGER-EVM Hi TI Experts,
My customer would like to evaluate the device of RF430CL331, but we could not find the evaluation board like RF430CL330HTB. Do you have any…
Hello Ralph,
I've already read the DLP-RF430BP BoosterPack datasheet and I see in the schematic that it doesn't include rectification circuit as shown in the image attached below, so I want to ask you are there any evaluation boards with RF430CL330H…
Hello Randy,
The filter caps on VCC should be 1uF and 0.1uF rather than both 0.1uF. I don't think that would cause the issue you see though.
Before going with the idea that the chip is blown, I would want to verify the same behavior doesn't occur…
Hello Christopher,
The RF430CL330H should work for your application. I would recommend using I2C with it. Also keep in mind as an NFC/RFID transponder, once the data is loaded in by the micro, the NFC reader device needs to prompt the RF430CL330H to…
Stephen,
If you just need a signal when the RF field is detected, you can tie a transistor to the Vcore pin of RF430CL330H. This will be 1.5V when the field is presented, even without power applied to Vcc. If you only want it to trigger from the field…
Hello Minhyung,
If it's just for research purposes and you aren't going into mass production with this application, you could use the RF430FRL152H over the RF430CL330H as an NFC interface. It's not cost efficient but that wouldn't matter in your case…
