Part Number: DLP3030-Q1 Hello Team,
We are developing HUD product using DLP3030 and we need to implement LED over voltage over current protection mechanism in our software. As per the below thread, it seems LED current and voltage cannot be read properly…
Part Number: DLP3020-Q1 Other Parts Discussed in Thread: DLP3030-Q1 , DLP5532-Q1 DLP3020-Q1, DLP3030-Q1 and DLP5532-Q1 recommended by your company as the interior projection solutions
Subject to the application scenario in the car, can the minimum projection…
Part Number: DLPC120-Q1 Other Parts Discussed in Thread: TMS320F28023 In this user guide page 12,the signal format is described Data is written on the falling edge and read on the rising edge. Is it understood that the MOSI and SIMO signals only change at…
Part Number: DLP3030-Q1 Hi,
We are developing an application based on DLP3030 using Q7 RGB LEDs.
Since the board is in house design we need some information regarding Temperature test.
What is the test setup required to test DLP whole unit temperature…
Part Number: DLP3030-Q1
Hi, I am trying to implement the read SPI command for VLED voltage and current (C5h) from TMS320F Piccolo and DLPC120. I am getting 4+4 byte Raw data (Voltage and Current).
I used the float conversion as mentioned in "DLPCU061_piccolo_SW_Guide_2018…
Part Number: DLP3030-Q1 Other Parts Discussed in Thread: TMS320F28023 Hello Guys,
I have a question about DLP3030-Q1.When I use my MCU to communicate with TMS320F28023 by SPI in order to change DLP3030's backlight brightness, though I can change it…
Part Number: DLP3030-Q1 The PGU red light has obvious jitter under low brightness setting. What might be the cause?
The setting is:
The phenomenon is:
Looking forward to your reply.
Part Number: DLP3030-Q1 Hello Guys,
I have the similar questions about safety critical application of DLP3030-Q1. Could you provide technical support on related issues?
Part Number: DLP3030-Q1 In the DLP3030 specification,it Supports WVGA (864 × 480) resolution ; The physical number of micromirrors is 683*608=415264 micromirrors; What is the relationship between the WVGA (864 × 480) resolution supported by DLP3030…
Part Number: DLP3030-Q1 Dears,
I have some questions about Photodiode selection
1. Are there specs on Photodiode? Are there selected criteria and conditions?
2. Is there any restriction on the placement of Photodiode in the optical machine (where can it…