Part Number: DLP6500FLQ Other Parts Discussed in Thread: DLPC900 , DLPR900
Hello E2E, Our customer is using DLP LightCrafter 6500 and having a problem. When the product is turned on and off, the existing pattern does not appear and there is no connection…
Part Number: DLP6500FLQ Other Parts Discussed in Thread: DLP650LNIR , DLPR410B , DLPC410 Hi,
I am looking to use this DMD chipset with an 808 nm quasi-CW laser. I am treating each of the pixels on the DMD as a diverging point source that I wish to collimate…
Part Number: DLP6500FLQ Other Parts Discussed in Thread: DLPC900 Hello,
The pattern I uploaded on the DMD is displayed all the time when the power is off. When I power DMD board pattern disappears but I am unable to connect via USB cable. I tried to run…
Part Number: DLP6500FLQ I am using a PRO6500 from Wintech Digital which uses the DLP6500. Currently using the TI LightCrafter 6500 & 9000 GUI to control the DMD.
My pulsed laser is operating at 100 Hz with a 10% duty cycle, yet there is significant…
Danilo,
I looked over this camera and it's specs. This camera is either rolling shutter or global reset with a phased readout which makes the exposure time different for different parts of the array of the camera. It can be done with some work, but…
Part Number: DLP6500FLQ Other Parts Discussed in Thread: DLPC900 Hello Team,
My customer has written some USB control software for a DLP6500 DMD controlled by a DLPC900. When they try to change video mode to "video pattern mode" they get a command failed…
Carlo,
My apologies, this would not load on our 6500 system. It has a problem with the 08 at the end of the second MBOX line and will not load further. I had started debugging the batch file, but did not get back to it.
I suspect that the trigger timing…
Part Number: DLP6500FLQ Other Parts Discussed in Thread: DLPC900 Please describe the input settings, on the 6500 GUI, that would display a single static binary image consisting of white and black pixels (not grayscale). In other words, we would ideally …
Hi Jiri.
Yes, you should not need a lot of electronics knowledge to get going.
We can set up a call. Just send me your email and we can find a time that works.
Regards,
Matt