Part Number: DLP9000XUV Other Parts Discussed in Thread: DLP9000 Dear all, I`m currently working on a zemax model for using DLP9000 for direct writing application. By any chance someone could share a Zemax example on how to implement a dmd model correctly…
Part Number: DLP9000XUV Other Parts Discussed in Thread: DLP9500UV We are now purchasing DMD products that can be used in the 355nm plused laser.
The products DLP9000XUV and DLP9500UV can be used in the band of<400nm, but the maximum illumination power…
Hi Mayumi,
I just read this entry. So far we have not received your request. Please use the following email address dlp@vialux.de. We will try to process your request as soon as possible.
Best
Phil @ ViALUX
Hi Marcos,
Thank you for the explanation of the resin issue.
Based on your measurements, yes, one bus is having a problem after the boards have been cleaned up. Fizix can review and provide feedback on next steps.
I do want to clarify one of your earlier…
Part Number: DLP9000XUV Other Parts Discussed in Thread: DLPC910 Hello
we are using the DLP9000XUV. The controller is DLPC910.
- The DLPC910 LVDS output is defined as LVDS-2.5V
- The DLP9000XUV LVDS input VCCI (Supply voltage for LVDS receivers) is defined…
Part Number: DLP9000XUV I am working on a DMD kit constructed by ViALUX (V-9001 UV), in which the DMD chip is DLP9000XUV. While I created a grey scale pattern for test (4x4, see below) and displayed it (only one frame, illuminate time = 4s, 8-bit, other…
Part Number: DLP9000XUV
Is it possible to design a DMD to operates with two states: off state and parked (flat) state?
From the answer of other similar questions, I've found that this type of operation has long term reliability issue.
But I think…
Hello Tim,
Are you able to measure (in pixels) the distance from one line artifact to the next one?
This type of artifact is typically the result of a poorly connected or not connected single LVDS line. Please check the Controller and DMD board pads for…
Michael
The DLP670S DMD is not rated per the data sheet to operate with 385 nm light. The lowest wavelength it is specified to use is 420 nm.
For an industrial 3D printer utilizing the 385 nm the TI DLP9000XUV https://www.ti.com/product/DLP9000XUV would…
Part Number: DLP9000X Other Parts Discussed in Thread: , DLP9000 , DLPC900 Hi,
We have DMD devices with DLP9000X and DLP9000XUV chips (V-9001 and V-9001UV, ViALUX). When doing the calibration of grayscale, we found that the output power is not proportional…