Part Number: DLPC7540EVM Other Parts Discussed in Thread: PCA9539 , DLPA100 , DLPC7540 , DLP650TE Hello,
We set up the purchased DLPC7540EVM and DPL650TEEVM according to the user guide.
I confirmed that I ran the Quick Start in Section 2 in order and completed…
Part Number: DLPC7540EVM Other Parts Discussed in Thread: DLPC7540 , PCA9539 , DLPA100 , DLP650TE
Hello,
I purchased DLPC7540EVM and DPL650TEEVM and received them today. I immediately set it up by following the quick start in Section 2 of the User Guide…
Here's a log from the device during boot:
DLPC7540EVM_UART_log.txt
----------------------------------------
Debug opened on URT0
I2C Port 1 initialized as Master port
I2C Port 2 initialized as Master port
I2C Port 0 initialized as Slave…
Part Number: DLPDLCR4710EVM-G2 Other Parts Discussed in Thread: DLPA100 , DLPA3000 , DLP4710 , DLP3010 , DLP2010 Hi, TI
Seeing TI's reference schematics, I made my new PCBA which has DLPC3440 + DLPA3000 + DLPA100.
I would like to write a project file to…
Hi made4engineering,
Please refer to attachments for Vx1 and FPD-link.
And would you please provide any log or example to show how it should be when FPD-link can be correctly detected?
Thank you
Sherman
vx1_1.txt
------------------------…
Hello Abby,
Thank you for using the DLP Forums.
The DLPA100 is a dedicated power and motor control driver for the DLPC4422 chipset. The motor driver function is primarily used for projectors that have a lamp, or laser phosphor, illumination source and…
Dennis,
I will check more on the FPGA part number and let you know
Also sorry for the confusion on DLPA part. For this design you have to use DLPA100 device.
www.ti.com/.../DLPA100
Regards
Anshul
Part Number: DLPC7540EVM Other Parts Discussed in Thread: DLP650TEEVM , , DLP650NE , DLP651NE , DLPC7540 Hi,
I have a brand new DLPC7540EVM, and DLP650TEEVM and it never worked properly out of the box. Am I correct in assuming that the dev board will switch…
I could not get the original DLPC7540EVM and DLP650TEEVM boards working again. I figured that I jacked up the firmware somehow. I was able to get the firmware downloaded, but I keep getting "Source instability flagged by Front-end!, restarting Autlock…
So the Serial J102 using TeraTerm just displays the commands that I send. Here is a snapshot from one session:
And another session which I presume shows the errors (maybe DMD Power problem?):
Command 0x0 execution took 52 us (greater than allowed 50 ms…
