Good afternoon JETER HSU ,
Attached is the Quality an Reliability test report for the DLPA300! --> DLPA300PFP_Qual_Pass.pdf
This took a little longer than expected because our quality team had to rerun the report for this PMIC device and we apologize if…
Part Number: DLPA300 Other Parts Discussed in Thread: DLPA200 , The datasheet does not specify thermal pin dimension and recommended stencil. Our PCB manufacturer said 10x10mm thermal pad with 60% stencil coverage is too big for the thermal pin it will cause…
Part Number: DLPA300 Other Parts Discussed in Thread: 1912-7037 Our customer has some questions about the product as below. Could you please give us some advise? Thank you so much!
Here is the part numbers:
TI Part Number
Description
2506224 …
Hello David,
I would suggest you checking the DLPA300 power up/down sequence and also checking the SCPEN, RESET and IRQ connections which connected to the fault logic block of the DLPA300.
Please refer to section 8.2.3 on DLPA300 datasheet and share the…
Part Number: DLPC3478 Other Parts Discussed in Thread: DLPA300 , , DLPA3000 , DLP3010EVM-LC Hi,
I designed a custom board with DLPC3478 and DLPA300 for DMD3010. I used W25Q32 as firmware flash and STM32 to flash the firmware and control the DLPC3478 I2C…
Part Number: DLPA3000 Other Parts Discussed in Thread: DLPC3438 Tool/software: Code Composer Studio Dears
DLPC3438 have a register 14H , it can set the image filp . DLPA3000 have a register 0X14 , It can set the output voltage of Buck 2, how to set…
