Other Parts Discussed in Thread: DLP5500 , DLPC200 Hi,
My customer is using the DLPC200 and DLP5500.
My customer uses a LVDS(200MHz) of the interface of DLPC200 and DLP5500.
However, EMI due to LVDS has come out strongly.
※ PCB layout complies…
Hello Kanji-san,
What is the difference of these two A and B?
[Sanjeev]
DLP5500 has two LVDS bus Bus-A and Bus-B and each takes 16-bit data. DLP5500 has also various configuration options where in which it can be configured to accept lower data…
Hello Seishin,
Looking at your list, since your customer have already designed board, all we can say is that, the O/P pins not a problem, but input pins to DLPC200 are very important. Ideally referring to Rev E is best.
The below lines are processed…
Hello Kanji-san,
We want to resummerize -
DLPC200 specifies after OE_N asserted the DATA must be valid within the 25ns; this is the MAX allowed timing; the controller beginning the reading out the data, after 25ns after making OE_N LOW.
tGLQV…
Hello Seishin,
It is processed same as PORT1_VSYNC signal. Referring to DLPC200 controller data sheet Video Input Pixel Interface section, the min value is shown 1.5ns or 1 PIXEL CLK time. Max pixel clock input is 80MHz i.e., 1 clk time would be ~12…
Hello Rossinag,
The DLLs and header files should be okay, i think using the dll and header file you should be able to build an application that can run on Windows 8.1.
I do see the driver installation procedure changed, it will now look for the digital…
Other Parts Discussed in Thread: DLPC200 Hello,
I would like to confirm reasons of changes of DLPC200 datasheet from rev D to revE in Aug.
Especcialy, I would like to know the pins handling chages are critical or not.
Best regards,
Hi,
There are differences between datasheet "dlpz004b.pdf" and Logic's DLP_Controller_Board_Schematic.
Which is correct?
schematic datasheet
RSVD_X12(U8) Pull-down No connection
RSVD_X13 (U7) Pull-up No connection
RSVD_X14 (AB17) Pull-down…
Other Parts Discussed in Thread: DLP5500 , DLPC200 Hi,
I asked earlier about Labview control of the DLP5500 through the DLPC200 and was told that I would require a USB peripheral CY7C68013 in order to use the API by Sanjeev. I requested more specific…
Dear E2E Community,
TI has not developed any Labview or Matlab code for the DLPC200/DLP5500 chipset systems. If you have done so and would be willing to share it with the community it would be very helpful to the original poster and many others.
Thank…
