Part Number: DLPC3430 Other Parts Discussed in Thread: DLPC3436 I would like to know the recommendation from TI about 0.4mm pitch BGA breakout (we are going to use DLPC3430CZVBR). What pad and via (via-in-pad) sizes do you recommend for 12-layer PCB board…
Part Number: DLPC3430 Our project use the DLP module to display. Because the limit of SOC, we only can use one MIPI lane. Can it support 854x480@60 with one MIPI lane?
Part Number: DLPC3430 Other Parts Discussed in Thread: DLP2010 , DLPA3000 Hi, we are using dlpc3040+dlpa3000+dlp2010 system for a projector product, during out prototype, we saw projector display has flicker.
we set the color bar test pattern from dlpc…
Part Number: DLP2010 Other Parts Discussed in Thread: DLPA2000 , DLPC3430 , Dear TI engineer, hello! We are working on lighting DLP2010+DLPC3430+DLPA2000. The equipment is currently lit and the pictures are drawn normally, but after we put the machine for…
Part Number: DLPC3430 Hi, is there any maximum time that the DLPC can wait to receive a valid DSI Signal?. After IRQ goes low, is there any interval I should respect to send video or that is not relevant.
Thanks
Part Number: DLPC3430 Other Parts Discussed in Thread: DLPA2005 , DLPA2000 I am designing board of DLPC3430 + DLPA2000 projection system , and i using the firmware of DLPC3435 _3.0.0_Firmware.img.
I want to modify the splash image by using the DLP LightCrafter…
Part Number: DLPDLCR2010EVM Other Parts Discussed in Thread: DLPC3430 , DLP2010 , DLPA2005 , DLPC3478
Hello,
I plan on designing a pico projector using the DLPC3430, DLPA2005, and DLP2010 chipset. Can you please send the updated firmware for these chips…
Part Number: DLPC3430 Other Parts Discussed in Thread: DLPA3000 Hi there—I have two questions with regard to the following statement in section 7.3.3.2 of the datasheet: "SPI0_CLK, SPI0_DOUT, and SPI0_CSZ0 I/O can be tri-stated by holding RESETZ in a…
Part Number: DLPDLCR3310EVM Tool/software: Hello, today when I was driving the DLPDLCR3310EVM, I encountered the problem that the DMD could not start normally. I then referred to the following website's methods, but it still didn't work. Please provide…