Part Number: DLPC350 hello:
We encountered the same problem as him, https://e2e.ti.com/support/dlp-products-group/dlp/f/dlp-products-forum/872123/dlpc350-writing-reading-to-from-i2c-master-port but Use the latest firmware program (DLPR350PROM-4p4p0…
Part Number: DLPC350
Hello, I would like to understand the pulse trigger of trig_in_1 in Trigger Mode 1 of the DLPC350 mentioned in the datasheet. Is it rising-edge only valid, or valid on both rising and falling edges?
I use this mode to trigger…
Part Number: DLPC350 Other Parts Discussed in Thread: DLP4500 , Hi there!
I previously received an answer for this question: https://e2e.ti.com/support/dlp-products-group/dlp/f/dlp-products-forum/1637451/dlp4500-what-gamma-curves-do-the-dlpc350-and…
Part Number: DLPC350 Other Parts Discussed in Thread: DLPLCR4500EVM Hi!
Are the OrCAD source File (.DSN) available for the eval board? I found the PDF but not the source.
DLPLCR4500EVM
Thanks!
John
Part Number: DLPC350 Other Parts Discussed in Thread: DLPLCR4500EVM , SN74LVC1G125 Dear Engineers: I encountered some issues while connecting to a PC using DLPC350, please kindly provide assistance. 1.I made a DLP control board using DLPC350. The basic…
Part Number: DLPC350 Other Parts Discussed in Thread: DLP4500 Hello TI,
After extensive operation of the DLPC350 device, we have observed that, on rare occasions, the TRIG OUT1 signal exhibits an unexpected notch during an active pattern sequence. Please…
Part Number: DLP4500 Other Parts Discussed in Thread: DLPC350 , According to DLPC350 Programmer’s Guide (page 38) the DLPC350 has two gamma curves: TI Video (Enhanced) and TI Video (Max Brightness). There is no other mention of these settings in the documentation…
Part Number: DLPC350 Tool/software:
Hello,
I hope you're having a good week. Could you please help me validate the correct FlashDeviceParameters for my DLPC350 ? I've attached the file from our servers for your review.
Thank you for your assistance…
Part Number: DLPC350 Hello TI Team,
We would like to approach this issue from a different angle. Could you please outline the exact steps required to ensure predictable and reliable behavior of the DLPC350 device?
Our current workflow is straightforward…
Part Number: DLP4500 Other Parts Discussed in Thread: DLPC350 Tool/software: Hi,
There are a couple of questions.
1. Is 0.03inches for DMD_DCLK Minimum Trace Spacing mandatory?
In some module, it seems to be different.
2. Is there any guidance…
