Hello Zeguang,
Do you use the PWR6 General purpose buck converter in your design?
If yes, and the PWR6 does not power up properly or a certain fault condition occurs, then this would pull down the INT_Z signal.
You can use GUI -> Advanced Mode -> Commands…
Part Number: DLPC6540 Tool/software: Hello,
I'm working with a Young Optics International 4k projector, the NVR-F, that uses the DLPC6540 internally. These are 4K projectors that use an XPR. My question concerns the read-only "Actuator Type" field of…
Part Number: DLPC6540 Other Parts Discussed in Thread: DLPDLCR471TPEVM , Tool/software: Dear Texas instruments forum,
I have designed a circuit board based on the schematic diagram in the following document, but I am unable to flash the boot program and…
Part Number: DLPDLCR471TPEVM Other Parts Discussed in Thread: DLPC6540 , Tool/software: DLPC6540 has only Vx1 input interface, DLPDLCR471TPEVM Front-End Board uses IT6807 for HDMI connector input.
Could you give me IT6807 datasheet or China sale's telephone…
Part Number: DLPC6540 I want to backup firmware in DLP471TPEVM via USB. I am use DLP EVM GUI 3.2.0.6.
I can get EVM Information .But when I want to backup firmware, it tell me "Firmware Backup Failed. Failed to switch to flash programming mode."…
Part Number: DLPC6540
Hello, I would like to find information on color coordinate adjustment (CCA), hue saturation gain (HSG), color space conversion (CSC), dynamic black (DB), and keystone correction for the DLP6540 series. Could you please let me know…
Part Number: DLPC6540 Hello, do I need to configure the software to implement the Lane remapping of DLPC6540 HSSI interface? We don't find any corresponding registers on the Software Programmer's Guide. Is it auto done? The same issue is…
Part Number: DLPC6540 My custoemr is asking for the voltage level specification for crystal A and B to control their materials.
Could I provide the specification for PLLMA? As I think the crystal provide a reference clock for the PLLs.
Part Number: DLPC6540 HI, I'm trying to boot up to a new DLPC6540 projector using the following workflow:
Connect to power via 24V PSU
Connect to my laptop via a USB to TTL connector ( this one)
Use pySerial to send serial commands over TTL.
Use ser…