Part Number: DLPC900 Other Parts Discussed in Thread: DLP670S , Hi, I am working on a design that uses dual DLPC900 controllers and a DLP670S DMD.
I have been using the DLPLCR900DEVM reference design as a resource but our custom design does not use HDMI…
Part Number: DLPC900 - first set up of new kit with DLP6750Q1EVM (DMD board) received Nov 2021
- GUI shows Connected with FW Version 6.10.178
- Status checked: Int Mem Test Pass, Controller/DMD Incompatible, Slave Present and Ready, DMD Micromirrors Parked…
Part Number: DLPC900
Hi Guys,
I'm posting this concern from our customer and we require your help to clarify things up.
question1：On the Dual DLPC900 EVM board, there are two DLPC900 controller chip, one is master function chip, another is slave…
Part Number: DLPC900
Hi,
At first we were having problems trying to get the Firmware to upload and we were getting the Flash IDs Error but then went into the flash device parameter and changed that so there were no more ID errors. Now when we try and…
Part Number: DLPC900
Hi so we are having a problem with adding images and uploading them into the firmware. We have followed all the steps listed in the User's Guide from section 3.9.1 on adding or removing patterns from the firmware. Every time we try…
Part Number: DLPC900 I am trying to avoid a frame buffer and use a USB3 to RGB conversion IC (Cypress FX3) for direct input to the RGB pins of the DLPC900. The FX3 IC would generate the PCLK, HSYNC, VSYNC etc.
The on-board buffering of that FX3 IC could…
Part Number: DLPC900 Other Parts Discussed in Thread: DLPLCRC900DEVM , DLPLCRC900EVM , DLP9000 , DLP670S , DLP500YX
Dear DLP Users,
Recently on E2E we have seen a number of issues with users facing challenges when trying to get their DLPC900 based EVMs up…
Part Number: DLPC900 Is this restriction still in place:
DLPLCR6500EVM: Wintech PRO6500 EVM :: Can not turn to Video Pattern mode at startup - DLP® products forum - DLP® products - TI E2E support forums
I am trying to configure a InVision project…
Hi Raymond,
Here is the detailed procedure on Storing 1080 one bit patterns on the flash memory and Displaying them in Pre-Stored pattern mode.
You might need to refer to EVM user guide and Programmers guide to understand all the operations in detail. …
Part Number: DLPC900 Dear TI E2E Managers,
Previously we have purchased DLP LightCrafter 6500. However the system was burnt due to reverse wiring at DMD end. As the strange smell and high temperature comes from the FPGA side, we suspect the FPGA was…
