Part Number: DLPDLCR2000EVM Other Parts Discussed in Thread: DLPC2607 Tool/software: Hello Texas Instruments,
I am currently working on transferring a buffer from an application processor to DLPDLCR2000EVM.
Could you please confirm the sampling type of…
Part Number: DLPDLCR2000EVM Other Parts Discussed in Thread: DLPC2607 Tool/software: Hello,
I'm working on connecting my application processor to the DLPDLCR2000EVM to transfer parallel data. I have connected the DATA0 pin of the application processor…
Part Number: DLPDLCR2000EVM Other Parts Discussed in Thread: DLPC2607 Tool/software: Hi,
In the datasheet, the EVM is listed as having a throw ratio of 1.6, but when measured during testing it appears to be closer to 2.2 (Throw distance / Image Width…
Part Number: DLPDLCR2000EVM Tool/software: Hello,
short question we have tested the DLPDLCR2000EVM and we have relaized
if it is running for a long time the lense housing starts to meld. Any possibility to
switch off the LED if we don't use the DLP?…
Part Number: DLPDLCR2000EVM Tool/software: When I try to connect BBB to laptop, it is not getting detected by PC(BBB drive is itself not showing) and leds are glowing, but it got connected and I am able to give commands in putty previously.
Please help…
Part Number: DLPDLCR2000EVM Tool/software: I have followed the procedure defined in [FAQ] DLPDLCR2000EVM: Quick-Start Tutorial - DLP products forum - DLP®︎ products - TI E2E support forums , but till step 13 it is ok and when I am trying to play fishbowl…
Part Number: DLPDLCR2000EVM Other Parts Discussed in Thread: DLPC2607 Tool/software: Hi,
I want to use BBB(Beaglebone Black) to control the DLPDLCR2000EVM and I follow this post( https://community.element14.com/products/roadtest/rv/roadtest_reviews/292…
Hello Kirthi, I checked the I2C pins on BeagleBone board, I used an MPU sensor to check, and I was able to detect it on the I2C bus with address 0x68, which was correct. I used the pins 1,3,19 and 20 on P9 of the BBB for GND, 3V3, SCL and SDA respectively…
