Hello Cathal,
Welcome back to the E2E forums and we hope to assist you with your questions.
What are your trigger settings in the GUI? Also note the following:
From the GUI it looks like you did not create any pattern and send it. You need to…
Hello Joselito Go,
Thank you for the information.
The top red LED is indicationg there is a fault status by the DLPC350 normally there should be a green LED blinking indicating everything is okay.
Can the customer look into a few issues:
1. Can…
Hi Tazawa,
Welcome to the E2E forums and we look forward to helping you with your questions.
I was checking online and we do have version 4.1.0 which is this following download I highlighted and there is a read me in there once downloaded.
https…
Hi Siket,
Welcome to the Forum, and thanks for showing interest in DLP Technology.
Please see the v3.1 firmware here : http://www.ti.com/tool/dlpr350
Thanks,
Navneet
Hello Tobias,
Welcome to the E2E forums and we hope to assist you with your questions.
There are certain blanking and timing parameters that must be followed to get 120 Hz working but we have tested and confirmed 120 Hz does work on a DLPLCR4500EVM…
Hello Mohamed,
I would check the following.
1.
I would check the following power signals. All of these are related to the DMD input power signals or power rails and first ensure these are all in specification.
2.
Can you also send a picture…
Hello Franz,
Are you using the self-compiled SDK or the pre-compiled SDK? Also are what operating system are you using and what firmware version of the LightCrafter 4500 are you using? You will want to make sure you have v4.0 which is available at…
Hello Matteo Fissore,
Welcome to the E2E forums and we hope to assist you with your questions.
As you mentioned, there is a difference between connectors so the DMDs will not be directly swappable. The DLPLCR4500EVM uses a FQE package connector for…
Hi Hirak,
Are you talking about the firmware "DLPR350PROM_V3.1: CURRENT VERSION -- DLPC350 Configuration and Support Firmware", version 3.1 from here ( www.ti.com/.../dlpr350) (the marked date is 14 Jun 2017).
I believe we are already using this …
Robert,
We have fixed the strange behavior issue with DMD park command as seen with F/W v3.1; this will fixed in new f/w revision v4.0.2. Please look into the DLPR350 F/W page for the update. Currently the new f/w is going under testing it will be available…
