Part Number: DP83867CR Hello team,
I have several questions.
1. Which pin is related to GPIO LED_3? I could only find LED_0, LED_1 and LED_2.
2. Datahseet says that RXD7 can be configured as LED pin. Is this correct? It seems like RXD7 should be…
Part Number: DP83867CR Hello team,
I am confused because this device has 3 VDDIO options of 3.3V, 2.5V and 1.8V. Is there any functional difference between them? How should I choose which voltage level to use for VDDIO?
Best Regards, Kei Kuwahara
Part Number: DP83867CR Hello,
We have simple question about MDIO port configuration.
It is I/O function port, during output mode, 2.2Kohms PU is recommended on datasheet.
We expect this is Open drain output port.
However actual measurement waveform without…
Hi Kailyn,
I don't believe I've asked this before, but are you able to read/write registers? I would also like to check the MAC's voltage level. Is it also operating at 1.8 V, like our PHY is?
Regards,
Alvaro
Part Number: DP83867CR Hello TI team, We are using DP83867CR, for Compliance testing we are referring this document : https://www.ti.com/lit/an/snla239c/snla239c.pdf?ts=1707443888787
We are able to set 10baseT, and 100baseT, for compliance testing. Whenever…
Part Number: DP83867CR Hello team,
I received question from the customer.
The customer did the MAU test with 10base and could not pass. It seems that the connector cannot be changed, is there any way to solve this issue?
Attached the waveforms.
Please…
Part Number: DP83867CR Hello TI team, We are using the PHY DP83867 with RZG2UL, getting problem in enabling it in u-boot. For that we have enabled, below u-boot configs
CONFIG_PHY=y
CONFIG_PHY_TI=y
CONFIG_PHY_TI_DP83867=y
CONFIG_MII=y
CONFIG_DM_ETH_PHY…
Part Number: DP83867CR Hello TI team,
We are using Ethernet PHY transceiver DP83867CR in our project. We want to build a 1000m ethernet connection between DP83867CR and a PC.
We got crossover connection between D3 and D4 pair in the layout. Our connection…
