Hi Craig,
The DRV8955 can be configured to switch high-side or low-side.
However, the DRV89xx-Q1 family of devices offers configurable high-side and low-side drivers as well. This family starts with DRV8904-Q1 (4 half-bridges) and goes to DRV8912-Q1…
Part Number: DRV104 Other Parts Discussed in Thread: DRV110 Tool/software: I'm looking to use the DRV104 as a solenoid driver with a DAC to change the duty cycle. The datasheet mentions voltage ranges corresponding to the set duty cycle and that is fairly…
Hey Todd,
Todd Jonas said: Is it possible to power up the DRV110 and enable it at the same time?
If it's possible, I assume there would be some short startup delay, what would that time be?
Yes, it is possible to power up the DRV110 motor driver and…
Part Number: DRV104 Hi Tech Support,
We need to actuate solenoid valves using spike & hold method. Please let us know if DRV104 driver is available as MIL grade or automotive grade? Also recommend us alternative IC for the same.
Part Number: DRV104 We are trying to develop a controller that will have a PID control of our proportional solenoid valves to control the pressure or flow based on the input command and feedback signal (coming from pressure or flow sensors). We need help…
Part Number: DRV104 Hello, I'm using 2 DRV104 and would like to sync them. So I will leave the master pin open on the master and ground the master pin on the slaves. Are the sync pins a direct connection between the DRV104 or should I put a resister between…
Part Number: DRV104 Other Parts Discussed in Thread: TINA-TI Anyone in the community can point me to DRV104 spice model that works with LTspice?
The model I've got from TI doesn't work. It gives me an error: U1:v1: requires a minimum of 5 parameters…
Part Number: DRV104 Other Parts Discussed in Thread: TCA9554A We wanted to add the latching circuit (didn't have it in the first working version) to our simple solenoid control board, but we hit an issue during schematic capture. I have attached a…
Part Number: DRV104 Other Parts Discussed in Thread: TCA9554A No one on our small team has little to no experience with motor/solenoid control layout, so we are looking for some suggestions/examples on best way to layout our DRV104-based board.
Our design…
