Part Number: DRV10983 Hi team.
What's the difference between DRV10983 and DRV10983-Q1? Can you summarize a comparison table? Can I replace DRV10983 with DRV10983-Q1 directly without changing the hardware and software?
Part Number: DRV10983-Q1 Other Parts Discussed in Thread: DRV10983 , , DRV10983EVM
Hello, I used a DRV10983EVM to acquire the motor parameters from my BLDC motor. It ran fine and I went ahead to design a standalone PCB with the DRV10983 and an ATmega324PA…
Part Number: DRV10983-Q1 Hi team
My customer has encountered an issue that they could not select the right motor for DRV10983Q1, their previous motor parameter is below:
The red part marked means the resistor 27ohm is too large and customer need a motor…
Part Number: DRV10983-Q1 Other Parts Discussed in Thread: DRV3205-Q1 , DRV10987 , DRV3245Q-Q1 , DRV3245E-Q1 What are the applications in which these ICs are actually used?
It would be helpful if you could tell us a couple of types.
Part Number: DRV10983-Q1 Hi
Pin SPEED can be adjusted for DC partial pressure. For example, when the partial pressure on the PIN is 1.5V and 2.7V, the SPEED is different.
However, in the PWM mode, you can not speed, either slow or full speed, PWM is 5V…
Part Number: DRV10983-Q1 Hello,
For the brushless motor there are 3 phases and GND. Can the GND connected to the DRV10983-Q1 be the battery GND separate from the motor GND? Or does it need to be the same reference as the motor for ripple counting or…
Part Number: DRV10983-Q1 Other Parts Discussed in Thread: DRV10983 , Hi Team,
I can see the Vin spec which is like VCC during load dump (VCC slew rate < 1 V/µs) –0.3 45V on the datasheet.
In this case, is it meets the ISO16750( http://www…
Part Number: DRV10983-Q1 Hello Team,
My customer is planning to use DRV10983-Q1 with regulator in linear mode. The do not have any external load to be powered from DRV10983-Q1.
Can they use 0.2W rated resistor instead of 1/4W?
Continuous max VCC voltage…