Search tips
Showing 63 results View by: Thread Post Sort by
    Answered

  • DRV120: MOSFET SPEC

    Resolved
    Part Number: DRV120 Other Parts Discussed in Thread: DRV110 , Team, The DRV120 integrates an internal MOSFET, whereas the DRV110 does not. Could you please provide the specifications of the internal MOSFET in the DRV120, including its voltage rating…
    • Resolved

  • DRV120: MOSFET SPEC

    Part Number: DRV120 Other Parts Discussed in Thread: DRV110 , Team, The DRV120 integrates an internal MOSFET, whereas the DRV110 does not. Could you please provide the specifications of the internal MOSFET in the DRV120, including its voltage rating…
    • Answered

  • DRV120: Can EN pin be left on at all times w/o voltage at Vin/Vs

    Resolved
    Part Number: DRV120 Hi Team I would like to control a relay using the DRV120. I have a DO from my system which switches b/n 24V (HIGH) and High impedance (LOW) This DO I would like to connect to Vin and Vs as it should be used to power/control…
    • Resolved

  • DRV120: Immidiatley fault

    TI Thinks Resolved
    Part Number: DRV120 Tool/software: Hello, I've made custom PCB with DRV120 to test ability for driving pull solenoids. Circuit schematic below. After drive EN pin to high logic level, status pin immediately trigger fault condition, even without any…
    • Answered

  • DRV120: Start-up delay（tD) is out of spec.

    Resolved
    Part Number: DRV120 Other Parts Discussed in Thread: , DRV110 Tool/software: Hi, Team Customer is testing our DRV120 about the Start-up delay（tD) , datasheets shows the delay is about 25us. But their test result shows it have about 25ms. Why is this…
    • Resolved

  • DRV120: solution for 1 Amp load

    Part Number: DRV120 Other Parts Discussed in Thread: DRV8231A , DRV103 , DRV110 Tool/software: Our actual PWM current regulator has been terminated. I'm looking for selenoid driver with current regulation. Requirements are: working voltage range…
    • Answered

  • DRV120: The fpwm is10khz with Rosc is 0 ohm.it is not meet datasheet, or it is nomal?

    Resolved
    Part Number: DRV120 Other Parts Discussed in Thread: DRV110
    • Resolved

  • DRV120: Supply voltage DRV120 26V or 28V

    TI Thinks Resolved
    Part Number: DRV120 Hello, I have a question regarding the maximum supply voltage of the DRV120. On the TI product page it is listed as 26V, in the datasheet on multiple occasions a supply voltage of 6-28V is mentioned. Yet, 28V is then listed in the…

  • DRV120:

    Part Number: DRV120 Hi, I am a newbie to PSpice. I downloaded the DRV120 Unencrypted PSpice Transient Model Package (Rev. A) from the product page: DRV120 data sheet, product information and support | TI.com When I try to run the PSpice for TI model…

  • DRV120: Output (hold) current not achieved

    Part Number: DRV120 Greetings. I am using the 8-pin DRV120, 24V source, 83ohm solenoid. With the 8 pin package, I cannot externally set the hold current - it should default to 50mA. However when the DRV120 is enabled, I'm only seeing ~10mA delivered …

Didn't find what you are looking for? Post a new question.