Part Number: DRV2510-Q1 Tool/software: Hello Team, following question missing in our datasheet:
---
Usually, we have an bandwidth of DC up to ~ 1-2 kHz.
Now, within a new design we want to use the DRV for a wider bandwidth signal.
The desired…
Part Number: DRV2510-Q1 Tool/software: Hello, I had two questions: 1) We are using the DRV2510 and have an LC filter at the output.
When we enable the DRV2510 we immediately get an over-current fault, even with no load at the output of the filter network…
Part Number: DRV2510-Q1 Tool/software: Hello, we have an application that the DRV2510-Q1 is perfect for; however, I noticed the minimum load impedance under recommended operating conditions is listed as 1.5 Ohms. Can you please explain what happens if…
Part Number: DRV2510-Q1 Tool/software: Hello,
We would like to DC-couple a single-ended input to the DRV2510.
We have a 0->1.8V DAC output voltage we would like to connect to IN+.
We want to be able to configure the DRV2510 to do both positive and…
Part Number: DRV2510-Q1 Tool/software: Hello,
I would like to have some help with the Failure Mode Distribution for the following part number DRV2510QPWPRQ1, this is usually included in the Functional Safety FIT Rate, FMD and Pin FMA report, but I cannot…
Part Number: DRV2510-Q1 Hi Expert,
My customer is selecting DRV2510-q1 as a haptic driver for vibrator.
The vibrator parameters are shown below:
The main concern from customer is that if drv2510 could output same drive curve under different…
Part Number: DRV2510-Q1 Tool/software: Hi team,
For this calculation, does the Lx stand for single L1 inductance? Does the CF stand for single C7 capacitance?
Part Number: DRV2510-Q1 Tool/software: Hello,E2E
link the related question How to configure the output sine wave
We rea d the EVM user guide.
At the same time, We have made changes to the LPF.
We plan to input a 180Hz PWM signal, and get a sine…
Part Number: DRV2510-Q1 Hi E2E,
We want to design a vibration motor application.
The motor requires a sine wave control signal of 160~200Hz 12Vrms.
Our schematic diagram is as follows:
We tried to configure 0x03 00h(20dB 400KHz) mode, but failed…
Part Number: DRV2510-Q1 Hi Expert,
My customer is using DRV2510-Q1 as the vibration feedback driver in their new project. They met one question and need your help to support.
Below is the actual output waveform from the MCU. After connect with IN…
