Part Number: DRV2605LEVM-MD Other Parts Discussed in Thread: DRV2605L Hi Experts, Our customer bought the drv2605levmd. He would like to know some information in regards of that. He is running 4 LRA Motors with two amplitudes: 154 and 179
He basically want…
Part Number: DRV2605LEVM-MD Other Parts Discussed in Thread: DRV2605L Hi,
Good Day. I have a customer who is working with DRV2605LEVM-MD. Please see below his query for your reference. Thank you very much.
I have a team of undergraduate biomedical engineers…
Hi Carson,
According to our customer, this is when everything is normal, the selected motors are vibrating.
They’re getting FF in the control register 3 and conf.reg as well sometimes. In that case, the motors are not vibrating but they can see on the…
Part Number: DRV2605LEVM-MD Hi Team,
Our customer would like to control the DRV2605LEVM-MD using Arduino Mega and had tapped to the I2C connector (3 pin connector) shown in Figure 23 schematic diagram of the User's Guide in the link below. R61 and R62 resistors…
Part Number: DRV2605LEVM-MD Other Parts Discussed in Thread: DRV2605L , Hi Team,
When the customer connects DRV2605LEVM-MD with HCC GUI, HCC GUI recognizes as DRV2605L instead of DRV2605LEVM-MD. Follow the instructions to upgrade the firmware, the original…
Part Number: DRV2605LEVM-MD Other Parts Discussed in Thread: DRV2605 Hi E2E, Good day. Could the DRV2605LEVM-MD manipulate the vibrating frequency and amplitude of actuators? What is the manipulating range? Regards, Carlo
Part Number: DRV2605LEVM-MD Hi
1;How to set the output of OUT5 and OUT6 at the same time when pressing the B1 button
2: When pressing B1 button, how to set the output time of OUT5 and OUT6
3: When the B1 button is pressed, whether the output waveform…
Part Number: DRV2605LEVM-MD Other Parts Discussed in Thread: TCA9554 , TCA9548A , DRV2605L Hi,
I'm working on a project using a Raspberry Pi to drive the 8 drivers off the DRV2605LEVM-MD over I2C. I had some brief success at first, but have recently…
Part Number: DRV2605L Hi,
I am testing a few LRA motor using the board DRV2605LEVM-MD with software "Haptic Control Console 1.5.4" (Firmware Version: TI-Haptics DRV2605LEVM-MD v1.3).
The "Run Auto Calibration" process always failed.…
Part Number: DRV2605LEVM-MD I have purchased the DRV2605LEVM-MD board and it won't turn on. I have been following the haptics control console and I can't seem to turn on the board when i connect it to the computer via USB.
www.ti.com/.../slou502…
