Part Number: DRV2667 Hello, I am trying to output a square wave (50Hz) while changing the amplitude in the range of maximum -50~50V from DRV2667 using a raspberrypi4+. I have set up the drv2667 in analog playback mode with the following program, but I…
Part Number: DRV2667 Hi Team,
The waveform can be output normally, and we can see teeth on the sine wave as the wave is amplified on the oscilloscope. Could you please share how to eliminate it?
The circuit diagram is done with reference to the development…
Part Number: DRV2667 I use I2C，control waveform generator enerate sine wave，but some santooth shape is on the sine wave. How to eliminate this sawtooth wave？thanks.
Analog input not used.
Part Number: DRV2667 Other Parts Discussed in Thread: DRV2665
Dear Technical Support Team,
According to the revision E,• Changed VDD MIN spec from 3.0 to 3.3.
What kind of effect will it have on the operation if it is used from 3V to 3.3V?
My supply…
Part Number: DRV2667 Other Parts Discussed in Thread: DRV2700 Hi , can I use this IC to drive constant (DC) output voltage ?
I mean to send some I2C commands to set constant output value (without sending I2C command always)
thanks,
Elimelech.
Hi Rajan,
Basic power consumption figures can be found in the datasheet.
the boost voltage is limited to 105V, so no you cannot drive a precise DC output up to 140V, however in differential AC configuration you can drive 140Vpp from the output.
Regards…
Part Number: DRV2667
Hello E2E Experts,
Good day.,
I am trying to use 3 DRV2667 Piezo driver chips on the same I2C bus but the I2C address seems to be locked to the same value. Is there any way the address can be programmed manually? Or is there a special…
