Part Number: DRV5032 Customer would like to know that what max. voltage derating Vdss of the open-drain output? Could you help to answer! Thanks.
Regards
Brian
Part Number: DRV5032 Hello,
We would like to use the DRV5032 in the TO-92 package (LPG). Would it be possible to get this device in pre-bent legs similar to the LP package: LP0003A LP (O-PBCY-W3) 4040001-2 and 4215214 (Rev. D) (ti.com) ?
Thank you…
Part Number: DRV5032 Hi Team
We are using DRV5032FCDBZR.
The Datasheet states that the time between points when the supply voltage reaches 1.65V and valid data on output pin is max. 100us.
But in our application the valid output data appears…
Part Number: DRV5032 Hi,
If a hall switch such as the DRV5032 were to cease operating, what would it's failure condition be i.e. would the output essentially be high impedance or would it pull to GND or HIGH?
Thanks, KM
Part Number: DRV5032 Hi team,
What is the power consumption in 5Hz with 3V supply? My customer cares a lot about the power consumption and i only found the consumption at 5Hz with 1.8V.
Or do u have better advice of hall sensors with lower power consumption…
Part Number: DRV5032 Other Parts Discussed in Thread: DRV5033
Hi,
I'm having a problem with DRV5032FA. Even though the positions of the magnet and Hall IC have not been changed, a signal indicating that the magnet is not detected is output at random…
Part Number: DRV5032 HI I could like check if DRV5032FBDBZT placement is close hotspot around 75 °C have any concern of if operating on 75 °C have other device can suggestion ?
Part Number: DRV5032 Hi Team,
Just want to confirm, what happens if the magnet is below the package? Would it be sensitive in the same manner?
What is the consideration when implementing below the PCB/IC?
Thank you.
Regards, May
Part Number: DRV5032 Other Parts Discussed in Thread: TMAG5123 , TMAG5328 , TMAG5124 Hi Team
There is a good new that we could DIN TI product!
My customer is currently looking for a Switch Effect Sensor.
They want to bury a magnet on the Lens…
