Part Number: MMWCAS-RF-EVM Other Parts Discussed in Thread: TIDEP-01012 Dear costumer service team,
in the document "Design Guide: TIDEP-01012 - Imaging Radar Using Cascaded mmWave Sensor Reference Design" you mention on page 4, that the azimuth angle…
Part Number: MMWCAS-RF-EVM Hi Support team,
Can the mmwavestudio display the value of angle estimation results? I didn't find it in mmwavestudio.
We need the angle estimation results to verify our algorithm.
Please kindly reply to me, thx.
Part Number: MMWCAS-RF-EVM Hi! TI expert!
I want to perform angle scans in the range of - 30 to 30 degrees at 2 degree step,using TXBF mode.I wonder whether low-level frame configuration can also complete this function?
There I try to define 31 chirps…
Hello,
Thank you for using the TI forum. Below are my responses to your questions.
1. Yes, it is possible to use this method for absolute angle detection. Our DRV5055-ANGLE-EVM does not store the calibration values in nonvolatile memory, but the the…
Part Number: DRV5055-Q1 Other Parts Discussed in Thread: LDC5071-Q1 , DRV5055 , TMAG5173-Q1 , TMAG5170-Q1 Tool/software: Hi Teams,
Can DRV5055-Q1 be installed with a side vertical axis like the 3D hall shown in the picture?
From the customer's perspective…
Hi, Rick:
The definition of angle resolution is when you have two object at the same range bin, the minimum angle difference that can separate the two target apart. The theoretically formula for angle resolution is pi/(2*(N-1)).
I am not sure about your…
Hi,
For incremental rotary encoding, the angle resolution will be dependent upon the number of magnetic poles
For example, in the incremental rotary encoding example in TIMSS, a 10 pole ring magnet with a 2D latch like the TMAG5110, we end up with ~18…
Part Number: AWR1843BOOST Other Parts Discussed in Thread: AWR1642BOOST , AWR1843 , Hi,
I previously asked about AWR1642BOOST EVM's beam formation angle, I had received response of -40 to +40 Degree
Can you please let me know the beam formation angle…
Andrew,
For minimum field, it's really that you need to get the AMR material into magnetic saturation
We have this specified at 20mT for this device. You'll find the linearity of the angle result may suffer if the material is not sufficiently saturated…
