The TI E2E™ design support forums will undergo maintenance from July 11 to July 13. If you need design support during this time, open a new support request with our customer support center.
Part Number: DRV5056-Q1 Tool/software: Hi Support Team,
The end customer is inquiring about whether performing plasma cleaning for 120 seconds on the PCBA will have any impact or potential risks to the DRV5056A2EDBZRQ1 component.
Part Number: DRV5056-Q1 Other Parts Discussed in Thread: DRV5056 Tool/software:
properties of magnetic disc require for sensing the magnetic flux density with the sensor part no:-DRV5056-Q1 also provide the reliability of the sensor
Part Number: DRV5056-Q1 Other Parts Discussed in Thread: DRV5056
Tool/software:
Hi,
What is the recommended position/placement of the sensor DRV5056 for current measurement?
What is the expected reading for the above two placements?
Thanks,
Ravi
Part Number: DRV5056-Q1 Tool/software: Hi Team,
I would like to ask if you have any information regarding the performance of DRV5056-Q1, specifically between -40C and +85C.
Do we have any impact on sensitivity, output voltage, etc? If so, do you have any…
Part Number: DRV5056-Q1 Hi,
I'm developing a position detection system to control the position of a shaft as it slides past the hall sensor (see my picture below).
Due to space constraints, the magnet is fitted to the shaft.
The air gap between the…
Part Number: DRV5056-Q1 I'm using a DRV5056A3-Q1 sensor in an application where the supply voltage Vcc=3.3V. I use a magnet with Br=1.26 diameter d=5mm and thickness s=1mm. The initial distance between the sensor and the magnet is 3.29 mm. The body on…
Part Number: DRV5056-Q1 Other Parts Discussed in Thread: DRV5056 , DRV5032
Hi, I want to understand supply current value. The sensor is typically taking ~6mA current at ambient temperature.
With change in temperature the supply current follows this curve…
Part Number: DRV5056-Q1 Hi,
The TI tool takes into consideration d1 distance from the surface of the sensor IC for sensing of distance measurement.
Whereas, the sensing element is placed at 0.47mm inside the IC from the surface.
Do we need to take into…
