Part Number: DRV632 Tool/software: There are the following questions about the UVP peripheral resistor design of DRV632
The cut-off voltage of UVP is 1.25V. In the design of external detection resistors, there are two formulas proposed, one is 6uA and…
Part Number: DRV632 Tool/software: Hi
Can you help review my customer's schematics? My customer encountered an issue that the output level is not high enough. thanks!
Part Number: DRV632 Tool/software: Hi Team,
As title, can I use the Vcc and resistor divider to provide the voltage to UVP to disable the IC?
Regards,
Roy
Part Number: DRV632 Other Parts Discussed in Thread: TPA6138A2 Hi Team,
Does DRV632 can drive 16ohm load? if it can, what's the minimum output amplitude under the condition of VDD=3.3V ，Load= 16ohm, THD=1%. Thanks.
Best regards,
Yang
Part Number: DRV632 Hi team,
Is there any guidelines or recommendations for trace impedance of DRV632's audio path?
My customer asked how much impedance should be(like 100ohm).
Thanks,
Jay
Part Number: DRV632 Hi Expert,
my customer is using DRV632 in smart speaker. we found output R show unnormal signal when MUTE the device. it seems like MUTE trigger the wired output signal. could you help to give some advice and check the schematic…
