Because of the Thanksgiving holiday in the U.S., TI E2E™ design support forum responses may be delayed from November 25 through December 2. Thank you for your patience.
Part Number: DRV632EVM Other Parts Discussed in Thread: DRV632 , DRV603 Hi team,
Here're 2 questions from the customer may need your help:
1) Regarding the UVP pin of DRV632PWR which is to prevent chip POP:
Below diagram is an application diagram of…
Part Number: DRV632EVM Other Parts Discussed in Thread: DRV632 , TPA6138A2 Hi Team,
We are looking for the replacement for competitor device.
Would you please provide your comment for the following schematic?
Schematic link
Two device
U5101 Stereo hp…
Part Number: DRV632EVM Other Parts Discussed in Thread: TINA-TI , , DRV632 , OPA1611
Tool/software: TINA-TI or Spice Models
Hi,
The result of an open loop analysis which is simulated with TINA-TI using DRV632EVM schematic is shown as below , it seems that…
Part Number: DRV632EVM Other Parts Discussed in Thread: INA1650 , DRV632 Hi,
Should the coaxial ground be connected with the power supply common(GND on DRV632EVM board) if using DRV632EVM as the transceiver board ? The ground loop isolation circuit is suggested…
Part Number: TPA3116D2 Other Parts Discussed in Thread: DRV632 , TINA-TI , OPA1611 , , TIPD118 , DRV632EVM , TAS6424 , TL431
Hi,
Could you please suggest the bridge IC for converting the Class-D amplifier output to the line output ? I am considering attenuating…
Other Parts Discussed in Thread: DRV632EVM , DRV603EVM Hello~
According to DRV603EVM & DRV632EVM, it is using the 16V voltage rating for the Charge Pump Flying CAP.
Is the 16V voltage rating mendatory??
If the VDD is 3.3V, Can I use 10V or 6.3V rating instead…
