Part Number: DRV8212
We're planning to use a large number of DRV8212's to drive two-wire linear motors. They'll be torque / current controlled, all with their own PI current controller. The way we do current control with 3-phase BLDCs is to use three…
Part Number: DRV8212 Tool/software: HI,
I found the following article.
https://e2e.ti.com/support/motor-drivers-group/motor-drivers/f/motor-drivers-forum/1404870/drv8212-is-there-any-motor-driver-which-has-a-function-of-load-monitoring?tisearch=e2e…
Part Number: DRV8212 Other Parts Discussed in Thread: DRV8837 I would like to perform SI, so would you be able to provide me with an IBIS model for the DRV8212DRLR?
I looked for it on your website, but it doesn't seem to be listed.
Thank you in advance…
Part Number: DRV8212 Other Parts Discussed in Thread: DRV8411 , DRV8210 , DRV8210P , DRV8410 ,
Tool/software:
Hi all,
I am considering a 2-channel H-Bridge motor driver for camera focus control. The package needs to be as small as possible and be…
Part Number: DRV8212 Hi,
I am working with the DRV8212DSGR motor driver and need to control a DC pump motor in both forward and reverse directions using only one microcontroller pin .
In my previous design, the pump was unidirectional, so a single…
Part Number: DRV8212 Other Parts Discussed in Thread: DRV8213 , , DRV8833 Dear Team,
We have an electronic door lock evaluation case/XE5008, and there is a need for a motor driver. 1.Single channel motor 2. PWM control interface 3. Vin: 5V Please…
Part Number: DRV8212 Other Parts Discussed in Thread: TPS62933 , DRV8220 Tool/software: Hi everyone,
I'm working on a project that controls a 12V DC motor using a DRV8212 driver IC. The motor needs to run forward and backward based on commands from…
Part Number: DRV8212 Other Parts Discussed in Thread: STRIKE Tool/software: Hi,
■ Phenomenon
MOTOR1 (normal unit): Forward and reverse rotation work correctly.
MOTOR2 (faulty unit): Forward rotation works, but reverse rotation does not occur…
Part Number: DRV8212 Hello,
After setting the half bridge mode and increasing the motor voltage during the test
U6 (on the right side of the circuit) used for the low side burned.
It was around 4.4A in the current monitor with CPU.
From the fact that…
Part Number: DRV8212 Other Parts Discussed in Thread: DRV8812 , DRV8412 Tool/software: Hello - I'm designing a non-standard, 2W inductive power system that will operate in the 100-1000kHz range. I'll probably used a fixed frequency and adjust the supply…
