Part Number: DRV8245S-Q1LEVM Other Parts Discussed in Thread: DRV8706S-Q1EVM
Dera Team,
I am working on DRV8245S-Q1 EVM now I have to connect DC high torque motor in connect as HS mode and run, as show in attached pic but when its go about to 1.2A…
Part Number: DRV8245S-Q1LEVM
Our team recently discovered an issue with the recently released DRV8245S-Q1LEVM. The EVM fails to connect to the GUI, and the nFAULT LED doesn't display the status of the nFAULT signal on the microcontroller. This is…
Part Number: DRV8245S-Q1LEVM Hello everyone, I have just unboxed this module and connected it to my PC and a 12V PSU.
The green Vm LED D3 comes on, as does the green PWR LED D6 but nothing else.
There is a bank of pins in connector J7 but no jumpers on…
Part Number: DRV8245S-Q1LEVM Hi There,
Could you please provide source Code for MSP430G2553IPW28R that is used in DRV8245S-Q1LEVM. We are planning to use the same approach and offload our CPU.
Is source code available?
Thank you,
Milen
Part Number: DRV8245S-Q1LEVM Hello everyone, I have just unboxed this module and connected it to my PC and a 12V PSU but am unable to get it to communicate with the GUI . I have tried every baud rate available (and each of the two serial ports that enumerate…
Part Number: DRV8245S-Q1LEVM Hi Team,
When testing the DRV8245S-Q1LEVM in the PWM mode, the input voltage is 12V with no load. There will be a voltage drop in the OUT1 and OUT2. Please see the pic below. What's the reason for that?
Thanks a lot …
Part Number: DRV8245S-Q1LEVM Hi
I see on previous forum mentioned there will be a new development board that allow us to change the PWM freq, is there any update on that.
Thanks
Part Number: DRV8245S-Q1LEVM Hi Team,
Customer wants to check if our EVM can change output freq to any other value instead of 20KHz?
I couldn't see any control for this in the GUI, thanks!
Andrew
Part Number: DRV8245S-Q1LEVM [Test condition]
* PH/EN mode
* 20kHz/50% duty
Hi, I have DRV8245S-Q1LEVM(SPI, 'S' variant), and try to use SSC(Spread Spectrum Clocking) feature because of EMC.
On datasheet of DRV8245, i can enable/disable SSC function…