Part Number: DRV8262 Dear Team,
A prototype was designed for BDC motors with a rated current of 1.5 A and was tested with the DRV8262-Q1. The motor was successfully operated under no-load conditions.
Design Details
The operating voltage of the…
Part Number: DRV8262 Other Parts Discussed in Thread: DRV8462 , Dear team,
We are using a 2-phase stepper motor with the following specifications:
Rated phase current:4A RMS
Winding voltage: 2.6V
Phase resistance:0.65 ohms
Phase inductance:2mH…
Part Number: DRV8262-Q1 Other Parts Discussed in Thread: DRV8262 , , DRV8163-Q1 , DRV8263-Q1 hello TI team
In my project,The DRV8262 use as a single H-bridge,voltage is 60V max, previously, through communication, I found that the leakage current corresponding…
Part Number: DRV8262 hello Murugavel
I have a question about device DRV8262DDW. Few weeks ago, we discuss about internal current architecture, the value of IPROP and the OCP.
I understand that: OCP is hardcoded and not possible to disable or change…
Part Number: DRV8262 Other Parts Discussed in Thread: , DRV8462 Dear team,
I previously designed a project using the DRV8262-Q1 for low-current applications, with a motor current of approximately 0.6 A during testing . I am now working on a new application…
Part Number: DRV8262 Tool/software: Hello,
Simliar question from this thread that I created yesterday. I figured that I should create new thread as I already marked it as completed. Same up is similar except that I cleaned up the bench and re-tested…
Part Number: DRV8262
Tool/software:
Hello,
I know that there is DDV package for DRV8262 and its EVM with a big heatsink.
Dose this EVM (DRV8262 DDV package) use of heatsink as main source of dissipating the heat? I was initially thinking of using…
Part Number: DRV8262 Tool/software: Hello,
I know that DRV8262 has current regulation and OCP circuit. Two questions here,
1) Can I understand that inrush current control is part of current regulation feature? Inrush current is high and short pulse…
Part Number: DRV8262 Tool/software: Hi again,
In DRV8262 datasheet, when power loss is calculated in the example below, it mentions that they use 22.2 C/W as Rja considering a JEDEC standard 4 layer PCB.
It seems that the example shown there is PWM…
Other Parts Discussed in Thread: DRV8262
Hello,
In DRV8262, it has current regulation feature which enable and disable transistors (PWM) when ITRIP level is reach as described in below figure.
My application is brushed DC motor that uses single…
