Hi Xiaoshan,
user6542167 said: I will make an estimate based on the documents you provided, and ask you if I have any questions.
Sure, thank you.
user6542167 said: 1. When was DRV8263-Q1 launched? I haven't found this information in February this…
Part Number: DRV8262-Q1 Heat Sink.pdf System Grounding.pdf
Thanks for your feedback heat sink reference but it is confusing when people go around throwing ground terminology and not referring to a real system grounding architecture, so I want to be…
Part Number: DRV8262-Q1 Reading through the design and layout notes the document referances that the Thermal pad of the DDW package that is attached at bottom of device should be referance to PWRGND. Assuming the PWRGND that is the referance to the VM…
Part Number: DRV8262-Q1 Hi Team,
Posting on behalf of our customer.
I want to use the device in direct drive mode, as in Table 6-3 (PH/EN) but want to control the device using truth Table 6-4 as the controlling logic for controlling to independent…
Part Number: DRV8262-Q1 Tool/software: DRV8262-Q1 , Does this driver can handle 7.1A , in the 48V system for 1.5sec , if we connect motor in a single H -bridge
Part Number: DRV8262-Q1 Other Parts Discussed in Thread: DRV8962-Q1 , Tool/software: i found one ic for driving DC Motors or Stepper motors.
Part number:DRV8962-Q1 : 65 V, Four-channel Half-Bridge Driver with Current Sense Outputs for 24V and 48V…
Part Number: DRV8262-Q1 Other Parts Discussed in Thread: DRV8262 , DRV8962-Q1 I want to use the second H-Bridge to drive a Brake coil only using the output from OUT3 and controlling ON/OFF with IN3 with IN4 tied to GND, The coil will be driven from VM…
Part Number: DRV8262-Q1 Tool/software: Hi,
I have an issue with all outputs; they are not responding to INx signals. I tried static voltage values and also 1 kHz PWM, with no difference.
VREF1 and VREF2 are set to 3.3V, FAULT input pin reads high…
Part Number: DRV8262-Q1 Tool/software: Is DRV8262-Q1 H bridge driver is of ASIL B compliance? If not can you suggest a H bridge driver with ASIL B ,for a 48V system .
Part Number: DRV8262-Q1
Tool/software:
Hi thank you all for your time,
For some reason I have for the OUT1/OUT2 in PH/EN and the OUT3/OUT4 in PWM. I realy want to have both in PWM if possible. The mode 1 is at ground and mode 2 is floating because…
