Part Number: DRV8300U Other Parts Discussed in Thread: DRV8300
Dear,
At datasheet page 18 of DRV8300U in equation (2), Vbstuv given as 4.5V instead of typical 8V.
Please check..
Thank u.
Part Number: DRV8300U Tool/software: Hello,
Would you be able to provide specifics on the integrated boot diode in the DRV8300U?
Specifically in the datasheet it says to limit current with capacitance above 1uF.
Thank you, Keith
Other Parts Discussed in Thread: DRV8300U Tool/software: Hi,
Using DRV8300U in my motor control product. Using TK100E10N1,S1X Toshiba , 2 mosfets in parallel for each section of 6 Mosfet bridges.
When phase current is more than 30 Amp, driver IC and…
Hi Philip,
Have you thought about implementing cycle-by-cycle current limiting externally? I'm not entirely familiar how this would be done but I did find a reference design where its implemented with three half bridge gate drivers
https://www.ti…
Hi Ryan
My post was not only mentioned for the usage of DRV8300U but this driver can be used for this new algorithm in the future. To whom must I send my appeal for collaboration about my new control algorithm of the BLDC-control?
best regards
zbyno…
Other Parts Discussed in Thread: DRV8353RS-EVM , DRV8353 , DRV8300U Hi,
I am testing/developing firmware with DRV8353RS-EVM + LaunchXL- F280025C for my 2 wheeler BLDC Hub motor referring Universal Motor Control Lab. Testing with eval board in parallel…
