Part Number: DRV8316-Q1 Tool/software: Hello Expert
When I was configuring register 4, I saw OCP_CBC and there was no introduction about it in the datasheet.
Can you clarify the functionality of this configuration?
I understand that changing the…
Part Number: DRV8316-Q1 Other Parts Discussed in Thread: DRV8316 , DRV8343-Q1
Tool/software:
Hi,
In our current project, we are considering the DRV8316-Q1 as a potential driver for three independent half-bridges due to its suitability in terms of…
Part Number: DRV8316-Q1 Other Parts Discussed in Thread: DRV8316 Tool/software: Hi, we are using a variant of your DRV8316 3-phase motor driver. The driver is powered from a 14V supply but we wanted the ability to drive the outputs at 5V TTL logic level…
Part Number: DRV8316-Q1 Other Parts Discussed in Thread: DRV8316 Tool/software: Hi Team,
There is an issue on CSA output waveform of DRV8316. Please check the waveform/schematic below and let me know the cause of this issue.
CSA output waveform.pdf…
Part Number: DRV8316-Q1 Other Parts Discussed in Thread: DRV8328 , DRV8320 Tool/software: Hi TI Team,
The customer is looking for a BLDC motor driver with 12V three-phase control.
Output voltage: 12V or higher
Output current: 16A or higher
Please…
Part Number: DRV8316-Q1 Other Parts Discussed in Thread: DRV8316C-Q1 Hi Expert，
I find the calculation forum on page 39 only related to Ia but not Ib.
Would you mind helping me to verify that if there is any problem on the datasheet?
Thanks a…
Part Number: DRV8316-Q1 Other Parts Discussed in Thread: DRV8316 Hi~ Team.
Customer is looking for 12V/50W BLDC driver solution, so introduced DRV8316-Q1 which peak current is up to 8A.
BTW, DRV8316 datasheet has up to 80W motor application, but…
Part Number: DRV8316-Q1 Tool/software: hi，
I have a question about IC_Status_Register Register:
Scenario:
I don't have a motor hooked up, and after running for a while, the nFAULT IO is pulled low and the value of IC_Status_Register Register is…
Part Number: DRV8316-Q1 Other Parts Discussed in Thread: DRV8316 Tool/software: We are using the 8316RQ for development and we need to modify the configuration via SPI because the current gain is not enough. During the modification we found that the MISO…
