Hi Ramya,
Thank you for the data.
That current (peak to peak) is very high, reaching nearly 60A (~ ±31A). The DRV8350EVM is only rated for 15A continuous current and 20A peak current, and so this is most likely resulting in the issues observed with overcurrent…
Part Number: DRV8350S-EVM Hi team,
I get trouble in installing the GUI of DRV8350S. I downloaded the GUI with the name of slvc754 and installed. When I click the button Desktop shortcut， it shows error
Could you please help me to figure out this issue…
Part Number: DRV8350S-EVM Other Parts Discussed in Thread: MSP430F5528 Dear TI Team,
I am currently in the process of designing a custom hardware solution for my BLDC Motor drive, drawing inspiration from the reference design (MD015A Design…
Hey Najma,
Marking the thread as closed for now. If your question was addressed please mark the thread as resolved.
Please let us know if you have more questions or if you have new questions please post them as a new thread.
Best, Akshay
Part Number: DRV8350S-EVM Other Parts Discussed in Thread: TIDA-01629 Hi Team,
After referring to TIDA-01629, the customer used this board to control the motor and found that the motor could not rotate. During the program debugging, it was found that the…
Hello Saikat,
I have sent you a private message regarding the IC so we will continue those conversations through those messages.
Q: There are 2 Option available for VM Pin of DRV8350 – We can Connect V-Motor net to VM pin which will have 60V or We can…
Part Number: DRV8350S-EVM Hi team
Regarding the DRV8350SRTVR gate driver, I want to know what is the maximum negative voltage between VDRAIN (pin 3) and SHA (pin 6).
This is actually the input to the op amp that senses the VDS voltage of the high side…
Part Number: DRV8350S-EVM Hi Team,
SLA will be compared with GLA inside the IC, but SLA is connected to GND. SLA is all 0V, why should SLA be FEEDBACK?
Thanks,
Annie
Hello,
Reference code can be found in the tool folder. Link below:
https://www.ti.com/tool/DRV8350S-EVM
Regarding your 2nd query, this is more of a tools question, so I will move to the appropriate forum to help you with that.
Regards,
Ryan
