Part Number: DRV8353RS-EVM Other Parts Discussed in Thread: DRV8353 Dear Sir/ Madam,
I am looking for DRV8353RS spice model. It would be really helpful if you can please share.
Thanks and regards,
Poojitha.
Part Number: DRV8353RS-EVM
Hi,
I am using the DRV8353RS-EVM to operate the BLDC motor, and I am controlling the motor speed using the GUI. I pressed the RESET switch S2 (FSMJSMA), and the EVM board began signalling the fault. I then tried to connect…
Part Number: DRV8353RS-EVM Other Parts Discussed in Thread: MOTORWARE , CCSTUDIO Currently, DRV8353RS-EVM kit is purchased and used. I followed the guide and installed MotorWare and UNIVERSAL GUI. All the copy paths in the guide were executed without any…
Part Number: DRV8353RS-EVM Other Parts Discussed in Thread: MOTORWARE , DRV8353
Previously, the online GUI was not linked, so we are proceeding it again through motorware. The current progress is as follows.
We are following the SLVUBH8B guide. 1. Installation…
Hi Youngtak,
To reduce redundancy I am going to close this thread since this topic will be continued on this recent thread here: https://e2e.ti.com/support/motor-drivers-group/motor-drivers/f/motor-drivers-forum/1314564/drv8353rs-evm-drv8353rs-evm-motorware…
Part Number: DRV8353RS-EVM Other Parts Discussed in Thread: DRV8353 Hello Team,
I am working on DRV8353 with F280015x interfacing with 48V ABZ+PWM Motor. On the UMC code I enabled the ABZ ENC feedback by enabling the "MOTOR1_ENC" macros for enabling the…
Part Number: DRV8353RS-EVM Other Parts Discussed in Thread: DRV8353 Hello Team,
I am working on DRV8353 with F280015x interfacing with 48V PMSM Motor with Hall feedback . At no load conduction Motor is working fine, motor all 3-phase current are same.
A…
Part Number: DRV8353RS-EVM Other Parts Discussed in Thread: DRV8353 Hello Team,
We Tried configured Universal Motor Controller sdk code based on F280025C to F2800157 Launchpad interface with Drv8353.
During debug mode, GUI Expression window ISR increment…
Part Number: DRV8353RS-EVM Currently with the EVAL firmware pulled from the EVM's site, everything has compiled correctly. The only issue is when using the DRV8353Rx GUI, there seems to be no action happening. Following the DRV8353Rx-EVMInstaSPIN SoftwareQuickStartGuide…
Part Number: DRV8353RS-EVM Hello Team
I am using hall feedback and a 48V PMSM motor. The motor is operating noiselessly and smoothly.
How to operate the motor so that it runs smoothly. What motor parameter settings need to be set up?
Best Regards,
…
