Part Number: DRV8412 Tool/software: Hi,
I'm looking to replace the DRV8432 which is EOL.
my application does not require higher current than the DRV8412 allows so it's the quickest replacement option for me.
question is can I rely on the DRV8412…
Part Number: DRV8412 Tool/software: The DRV8412 datasheet states "up to 2 x 3A continuous output current (2 x 6A peak) in dual full bridge mode" but the pulsed peak current per output pin (Io_pulse is 15A).
My interpretation of this is that…
Part Number: DRV8412 Tool/software: Hi,
In this thread, Rick is suggesting that not having individual control over each half bridge reset could cause a problem driving a BLDC motor with the DRV8412. Can TI please elaborate on the problem that this could…
Part Number: DRV8412 Tool/software: I am using a microcontroller with 0 to 3.3V digital outputs to control the PWMA-D lines on the DRV8412. I noticed in the DRV8412 datasheet that the maximum high-level input voltage is 3.6V. Does this mean that 3.3V…
Part Number: DRV8412 HI We have some parts DRV8412 and we are trying to indentoify what the other marking on the first line is.
The marking are 34A28JTG4 or 89C3SLTG4.
We are need trying to figure out the marking.. I could not find any reference to the…
Part Number: DRV8412 Other Parts Discussed in Thread: DRV8320 , CSD88584Q5DC , Hi,
We are using the DRV8432 driver for years to control two L-C tank resonators, one for each Full Bridge. As known DRV8432 is obsolete and we are looking for an alternative…
Part Number: DRV8412 Tool/software: e2e,
I seem to have observed a higher current through the Vdd vs. what is published in the datasheet [10.5mA at 400KHz 50% duty]. I measured an RMS current of 68mA driving a load at 300KHz with a 25% duty cycle . The…
Part Number: DRV8412 Tool/software: 1. How to set up CBC and OCL mode? Can I only use CBC mode alone and turn off the overflow self-locking?
2. Monitor which position can well monitor the overcurrent protection, and which position with the oscilloscope…
Part Number: DRV8412 Dear TI experts,
My customer now tests their own PCB with DRV8412. Could you review the schematic below?
The problem is, they use this circuit to operate peltier.
if the duty of PWM is under 50%, it is okay. (about under 5A current…
