Part Number: DRV8424E Other Parts Discussed in Thread: DRV8701 , , DRV8412 , DRV8844 , Our original design using DRV8701 to drive a motor in PH/EN mode, but the input deglitch filters causes the output to have jitter which cause small audible noise when…
Part Number: DRV8424E Hi team,
DRV8424PPWPR is used for driving DC Brushed motor in PWM mode.
But the motor can only be turned forward, not reversed.
IN1=1 IN2=0 IS WORK OK
IN1=0 IN2=1 IS BAD
The CPU program uses the simplest level control in1…
Part Number: DRV8424E Other Parts Discussed in Thread: DRV8256 Can both pairs of channels on the DRV8424E or DRV8424P be run in parallel to up the amperage to 5A? If not, is there an upper limit to the parallel current operation?
Looking for maybe…
Part Number: DRV8424E Other Parts Discussed in Thread: DRV8424 Hi team,
Here's an issue from the customer may need your help:
There're 6 decay modes of DRV8424, how to select them? Could you help elaborate the application scenario respectively?
…
Part Number: DRV8424E Hello,
I need to drive two DC brushed motors with speed control.
I was looking at DRV8424E/P datasheet:
I know that both DRV8424E and DRV8424P have an internal PWM (depending on VREF) to limit the inrush current, but my doubt…
Part Number: DRV8424E Other Parts Discussed in Thread: DRV8424 , ,
As shown in the figure above, can several configuration pins be selected high or low by a dial switch? According to the specification, it can be connected directly to GND, as…
Part Number: DRV8424E Hi Team,
Our customer is looking for motor drivers to drive 4 brushed coreless DC motors from Faulhaber ( https://robotdiscounter.com/kp0001-dc-motor-with-encoder ). Because most of the suitable motor drivers are out of stock,…
Part Number: DRV8424E Hi,
The data sheet states that all FETs are current overload protected but the circuit shows the sense circuit ONLY on the low sides.
Page 10 Iocp is given as "all FETs" but as just a +ve value.
So are the high side FETs…
