Part Number: DRV8702-Q1 Hello MD team,
my customer BROSE has a question regarding the DRV8702-Q1 H-brigde driver.
When the DVDD or AVDD output is shorted to ground, as may happen by a stray particle on the PCB, the gate drive outputs GHx/GLx will…
Part Number: DRV8702-Q1 I am looking for an alternate part to replace the DRV8702 part we tested in our circuit.
Our input is rectified AC (lumpy DC) with very little capacitance. This part turns off our output when the UVLO condition is met. Bypassing…
Part Number: DRV8702-Q1 The DRV8702-Q1 component datasheet specifies that the recommended capacitor between pins VM (pin 28) and VCP (pin 29) is 1uF. Due to an assembly error, a 0.1uF 50V X7R ceramic capacitor was incorrectly installed on a BOM. For some…
Part Number: DRV8702-Q1 Hello;
Q3 2021 we replaced the DRV8702-Q1 in our design by an other motor driver because of availability.
Because of EMC reasons we want to change it back.
At TI online shop the maximum order quantity of the DRV8702-Q1 is…
Part Number: DRV8702-Q1 Tool/software: Hi Team,
When we are having test with DRV8702-Q1 and MOSFETs, the output current can be pulled low by some reason. Could you please share some insight on this?
We found this issue both with eLoad and real power…
Part Number: DRV8702-Q1 Tool/software: Hello team,
DRV8702 After the chip is powered on, in order to ensure that the VCP output is up to 23V high level voltage, does it only need nsleep to pull up? Is there a problem if the DRV8702 output is not driving…
Part Number: DRV8702-Q1 Tool/software: Hello,
Due to a manufacturing error a zero ohm Resistor was left out during production which connects the Drain pin of the N-Channel mosfets of the H-Bridge to pin 27 on the DRV8702-Q1. We didn't realize that it…
Part Number: DRV8702-Q1
Tool/software:
Hi,
I have recently received my prototype board for the H-bridge DC motor driver circuit using the DRV8702-Q1.
Schematic can be referred in this thread: DRV8701EVM: Queries on the output current limit …
