The TI E2E™ design support forums will undergo maintenance from July 11 to July 13. If you need design support during this time, open a new support request with our customer support center.
Part Number: DRV8703D-Q1 Other Parts Discussed in Thread: DRV8703-Q1 , Tool/software: Hey,
I'm working on a development project that involves the DRV8703. I'm pretty new to Motor Drivers and Motors, and I'm a bit confused about the Terminology.…
Part Number: DRV8703D-Q1 Other Parts Discussed in Thread: DRV8703-Q1 , , DRV8106-Q1 Tool/software: Hi team - I see DRV8703-Q1 has a FIT, FMD, and Pin FMA report, but the DRV8703D-Q1 does not. Can the DRV8703-Q1 FIT, FMD, and Pin FMA report be used for the…
Part Number: DRV8703D-Q1 Tool/software: Hi,
The customer is using DRV8703DQRHBRQ1.
1. Could you tell me if each GND pin (1 and 13, 17, and 25 pins) is conductive?
When the customer checked the conduction of each pin with a tester, the following results…
Part Number: DRV8703D-Q1 Tool/software: Hello TI team, thank you for your support. I'm aware of the difference between functional safety capable device where TI provides base FIT rates and failure mode distribution data and leaves it to the integrator…
Part Number: DRV8703D-Q1 Other Parts Discussed in Thread: DRV8702D-Q1 , TI Team,
Is it possible to configure high-side breaking in DRV8703D-Q1 / DRV8702D-Q1 ?
Customer needs:
The only HB IC version is needed.
current regulation is needed.
high-side recirculation…
Part Number: DRV8703D-Q1
The block diagrams in the DRV8703D-Q1 datasheet show the negative terminal of the motor connected at the SP pin. Thus, in the "slow decay" mode ("off" half of a PWM cycle), the freewheeling current flows through the low-side…
Part Number: DRV8703D-Q1 Other Parts Discussed in Thread: DRV8703-Q1 , DRV8703-Q1EVM The DRV8703-Q1 datasheet clearly specifies the SPI mode configuration (mode 1).
After hours of debugging our board, we decided to probe the D RV8703-Q1EVM dev board to…
Part Number: DRV8703D-Q1 Hi Team,
my customer has issues with conformal coating. As you can see in the picture in the red circles
only the left upper device has a appropriate coating. On the rest of the parts, the paint has retreated after painting.
The…
Part Number: DRV8703-Q1 Other Parts Discussed in Thread: DRV8703D-Q1 Hello E2E,
Can you list the differences between DRV8703-Q1 and DRV8703D-Q1?
Thanks!
Russell
Part Number: DRV8703D-Q1 Thank you for your response. I only have one more question: if pin 23 (SL2) is floating besides what you mentioned the issue the device could generator over current fault due to the pin floating? if that is true then gate drive…
