Part Number: DRV8714-Q1 Tool/software: Hello,
When DRV8714-Q1 is used as H-Bridge, I would like to know that how ~5.3V is appearing at SH1 and SH2 during offline diagnostics in the case of no fault.
Thanks,
Sathish.
Part Number: DRV8714-Q1 Tool/software: Hi team,
Is there a failure mode in the DRV8714 and DRV8703 chips that will cause the diagonal MOS of the H-bridge (such as the left high side and the right low side) to turn on at the same time?
This is a requirement…
Part Number: DRV8714-Q1 Tool/software: Hi All ,
Requesting DRV8714 register configuration for Hbridge activation using PWM . I have hurdle in achieving the below status
Part Number: DRV8714-Q1 Tool/software: Hello team.
I would like to know what the path will be when 5V is applied to the NSLEEP/DRVOFF/NSCS terminals while PVDD and DVDD are open.
As ECU of the failure mode check, we check the behavior of the IC…
Part Number: DRV8714-Q1 Tool/software: Hello,
I am planning to use 2 BDC motors to be controlled through H-bridge circuit by PWM inputs from microcontroller. From the datasheet of DRV8714-Q1, I referred below table where I am not bit clear on the…
Part Number: DRV8714-Q1 Tool/software: Hi team,
My customer is facing a issue when using DRV8714-Q1.
When they try to increased the duty cycle from 0% to 100% w/ duty step 10/1024 every 10ms, and they found that when the duty cycle is close to 100…
Part Number: DRV8714-Q1 Hi team,
Our DRV8714-Q1 internal CSA cannot meet customer application requirements, do we have any guidance how to calibrate the CSA and any calculator for CSA accuracy?
Also could you please help share any design guidance…
Part Number: DRV8714-Q1 Tool/software: Hi team,
If customer sets DRVOFF to 1. How will the MOSFETs be turned off? With IDRVN or passive pulldown? Thanks!
Best Regards
Grey
Part Number: DRV8714-Q1 Hi Team,
DRV8714-Q1 Pin 3~6 in figure 6-5/6 shows below.
On the other hands, its table 6-3 shows below.
which one is correct?
Regards,
Kai
