Part Number: DRV8816 Tool/software: Hi Team,
When the machine is powered on and the chip is in a high resistance state, a multimeter is used to measure that OUT1 and OUT2 have a ground voltage of about 12V.
After pulling up the resistor, a leakage…
Part Number: DRV8816 Other Parts Discussed in Thread: DRV8876 , , DRV8873 , DRV8874 Dear Sir/Ms.
Because DRV8874/DRV8876/DRV8873 is out of stock, my customer wants to find replacement materials. His motor specification is 24V, 3A (Max continuous), brushed…
Part Number: DRV8816 Hi,
We were using motor driver from Allegro MicroSystems (A4952ELYTR-T) in one of the project. Now customer wants to change the motor driver to DRV8816, and should work with existing firmware. I have compared control interface table…
Part Number: DRV8816 Dear All:
I want to use the DRV8816 to drive the resistive load , but I find the Sense Pin is not correct. can the Drv8816 drive the resistive load or only drive the motor load? Thanks~
Part Number: DRV8816 Other Parts Discussed in Thread: TM4C1290NCPDT Hello,
I am using a DRV8816 EVM board to run a uni-directional solenoid using three methods.
Method 1: The solenoid is connected between the OUT1 and OUT2 pins. The solenoid works…
Part Number: DRV8816 Other Parts Discussed in Thread: DRV8844 , , DRV8872 , DRV8842 , DRV8873 Hey there!
I am developing a product that needs to support two different usecases:
1) driving one bidirectional solenoid in a full h bridge mode. 2) driving…
Part Number: DRV8816 Other Parts Discussed in Thread: DRV8801 Hallo!
I am using DRV8816 EVM to test the DRV8816 motordriver IC. I want to use the VPROPI pin to control the current through the motor ( i know that it is not measuring anything during fast…
Part Number: DRV8816 Hi I tried to extend the 1,6 ms tOCP Time by connecting the nFault pin to the enable2 pin. These both pins are connected directly. To realice the default High level I made a resistor divider with 15K against 24V and 3K3 to GND. To…
Other Parts Discussed in Thread: DRV8816 , DRV8818 , DRV8848 , DRV8847 , DRV8846 art Number: DRV8816
Hi team,
My customer is choosing the motor drive IC for their designated as below motor.
And, it has the collocation solution of MTD2003 as below…
Part Number: DRV8816 Hi
In the Datasheet ist a maximum Voltage of 7V specified for IN1/2, EN1/2, nSLEEP. Is it possible to aktivate the Outputs permanently with a perhaps 10K resistor against 24V or should I make a resistor devider?
Kind Regards …
