Part Number: DRV8833C Other Parts Discussed in Thread: DRV8833 Hello,
I am using the DRV8833C to drive a stepper motor, (rotation freq is 8Hz) the driver is in full step and everything seems to be ok (PWM stable and shifted for each 2input) figure 1…
Part Number: DRV8833C Tool/software: Hi,
Good day.
Pertaining to PN#DRV8833CPWPR, may I know of this part support current adjustion or not?
If yes, how to adjust the current? Could you please reveiw and advise?
Thanks.
Regards,
Kent
Part Number: DRV8833C Other Parts Discussed in Thread: DRV8210 , DRV8832 Tool/software: Hi Sir,
My customer is looking for a lens motor driver shown as the below spec, could you please advise the solution? Thanks!
Zoom: 190mA(typ), 320mA(max) ND…
Part Number: DRV8833C Hi,
I'm evaluating the DRV8833C for use with our stepper motors. Section 8.2.21 of the spec sheet states: The DRV8833C can support full- and half-stepping modes using the PWM interface
Does this mean that the DRV8833C does not…
Hi 2018,
Can you provide a figure or table for 8-shot control? The figures did not appear in the original post.
If possible, please also provide the motor specification.
Part Number: DRV8833C Hi team,
In case of using device in parallel mode, is it OK to tie AISEN and BISEN with same Rsense as attached schematic?
best regards,
Part Number: DRV8833C Other Parts Discussed in Thread: DRV8833 , Hi,
Good Day. I have a customer who is working with DRV8833/C. Please see below his query for your reference. Thank you very much.
I am interested in using both DRV8833PWPR and DRV8833CPWPR…
Part Number: DRV8833C Other Parts Discussed in Thread: DRV8833 Hi Team,
My customer now use DRV8833C in printer solution (phase register is 10 ohm and current is 300mA)
① Customer now both AISEN and BISEN are connected to GND. How big…
Part Number: DRV8833C Hi Team,
When using the DRV8833C, use MCU to control IO, and output to AIN1 and AIN2. AIN1 is a PWM wave (50Khz frequency, 50% duty cycle), and AIN2 is 0V. Test with a multimeter, the waveform between AIN1 and AIN2 is correct.…
Part Number: DRV8833C Hi ,
On its datasheet appears equation#4 : I,FS(A) < ...
1. whats is I,FS(A) ?
2. what is the relationship between I,FS(A) and I,CHOP ?
3. The VM=5V , motor RL is 40 Ohm while the Motor has 2 phases (that can work in parallel…
