Part Number: DRV8874EVM Other Parts Discussed in Thread: DRV8874 Hello team,
The previous post is closed, so bringing it up again.
On the EVM what is the Maximum Low-Level Current of the open-drain-transistor (DRV8874) for the nFault pin?
Where…
Part Number: DRV8874EVM Other Parts Discussed in Thread: DRV8874 Tool/software: Hi,
I connected a motor to OUT1 on the DRV8874EVM and am operating it in PMODE = logic low. I can control the motor as desired using the EN/IN1 PWM potentiometer.
The…
Part Number: DRV8874EVM Tool/software: Hello TI Team,
I am using the DRV8874EVM connected to our motor with the specifications per below.
The EVM’s PMODE is configured to GND for PH/EN Control Mode, set up for single motor operation. The EVM board…
Part Number: DRV8874EVM Other Parts Discussed in Thread: DRV8874 Hi team,
Can DRV8874EVM be used to drive stepper motor?
If it can do that, how should I need to modify the EVM?
Regards,
Itoh
Part Number: DRV8874EVM Hello experts,
I just want to clarify a little thing about DRV8874EVM.
In the EVM schematic, there's 10k resistor(R14) connecting to the nFAULT.
However, nFAULT looks like connecting to the MCU through the jumper on the EVM…
Other Parts Discussed in Thread: DRV8876 , DRV8874EVM We have planned to use the KHLVA-101-5-P part in one of our projects
Do you have any controller to drive this device?
For your reference below i shared the link for KHLVA-101-5-P part
https:…
Hello,
1. Recommended C2000 Development Board
LAUNCHXL-F280025C (C2000 LaunchPad): This is the ideal starting point. It is low-cost, provides the necessary debug interface (XDS110), and has sufficient GPIOs and PWM modules to interface with motor…
Ryan-san,
We have confirmed that the DRV8874EVM works as expected.
However, simulating with the same settings will give different results.
The model is different from the actual behavior.
Please correct the spice model.
Best Regards,
DRV874EVM…
