Part Number: DS125BR111 Hi Experts,
I use DS125BR111 on 3.3V mode, and I would ask a decoupling capacitor's value.
I look a datasheet and it is described "3.3V mode, decouple each VDD pin with 0.22uF cap to GND." in the Pin Functions table. On the…
Part Number: DS125BR111 Hello, I'm looking at the data for DS125BR111RTWR. I see that the part is rated only to -40°C for low operating/storage temperature. This part was apparently tested to -65°C during temperature cycling. I had two questions here…
Part Number: DS125BR111 do DS125BR111 support SGMII /1000base-kx ? we have design that connects one ETH PHY1 1G port to ETH PHY 2m away(about 60 inch ) by 1000base-kx .
the PCB trace also need to pass through a backplant 。
do DS125BR111 support 1.25bps…
Part Number: DS125BR111 Other Parts Discussed in Thread: DS160PR410 Hi TI E2E,
Do either the DS125BR111 or the DS160PR410 offer a PCIe pass-through mode whereby the the PCIe signals are passed through the IC without any signal processing. If so, how is…
Part Number: DS125BR111
Hi, Support Team
Could share document about DS125BR111 of maximum trace length and insertion loss spec?
we just saw datasheet
9.2.1 Design Requirements As with any high speed design, there are many factors which influence the overall…
Part Number: DS125BR111 Hi Experts,
I would use DS125BR111 for SAS-3 interface redriver and am consider setting. Now I have some questions about this device. I use it on pin-mode as ENSMB=0.
1) I set the EQA0/EQB0=1 (LEVEL4), VODA_DB/VODB_DB=0 and VOD_SEL…
Part Number: DS125BR111 Other Parts Discussed in Thread: TUSB1002A Hi, Experts,
I would use DS125BR111 as a redriver for USB GEN1/5Gbps and GEN2/10Gbps. Are there any technical points for the design on board trace, setting and so on?
Best regards,
Te…
Part Number: DS125BR111 Hi Experts,
I would use a DS125BR111 as redriver for 12Gbps SAS-3 interface and am designing a printed board. In this case, is there any typical tolerance for equal length trace for differential Tx/Rx lines?
Best regards,
Tets…
Part Number: DS125BR111
Is the 1KOhm resistor highlighted in the image above the Rterm discussed in the Table?
Trying to discern if the table is talking about the pull-ups on the I2C line or on the ENSMB pin.