Part Number: DS90LV027A Other Parts Discussed in Thread: SN74LVC1G17 Team,
Does the DS90LV027A have any input hysteresis? My customer's application requires it, but looking at the electrical specs this device does not seem to have it. Can you please…
Part Number: DS90LV027A Is it ok to AC couple the outputs of the DS90LV027A? In the datasheet, it says that AC or unterminated configurations are not allowed. But if the LVDS RX in the system has integrated 100Ohm termination and internal biasing, then…
Part Number: TMUXHS4212 Other Parts Discussed in Thread: DS90LV027A , LMK1D1204P Tool/software: If Vcm = 0v-1.8v, and Vdiff = 1.8v so each pin can go 0.9v above/below Vcm) as specified in the description paragraph in the first page of the datasheet, this…
Part Number: AMC1035-Q1 Other Parts Discussed in Thread: AMC1035 , ISO7740 , DS90LV027A , DS90LV028A , AMC1210 , AMC1336 Hello,
in the datasheet of AMC1035 is written: " The modulator bitstream on the DOUT pin changes with the rising edge of the clock…
Part Number: DS90LV028A Other Parts Discussed in Thread: DS90LV027A Dear team,
My customer would like to use 3.3V single-ended input to feed in DS90LV028A input side.
Since DS90LV028A is differential LVDS input and SE output. Is there any risk about…
Other Parts Discussed in Thread: DS90LV012A , DS90LV011A , DS90LT012A , DS90LV028A , DS90LV027A , THVD1450 , SN65LVDT41 , DS90UA101-Q1 I'm looking at sending around 50 Mbps of data over a cable about 3 ft in length. None of the MCU have UART that can…
Hello I.K
I would like you to confirm following additional questions.
Q1. Is it possible to connect SN65LVDS1 as Driver(Supply voltage : 2.5V) and DS90LV028A as Receiver(Supply voltage 3.3V) ?
Q2. Is it possible to connect GND for input of SN65LVDS1…
Hi,
What is the distance between the two PCB?
To run SPI up to 80MHz with LVDS, very likely you need to consider round trip timing delay issue. Please email me at y-cai@ti.com. I could share an upcoming TI Design guide on SPI over LVDS.
If wide…
Hi Jyothi,
The SN65LVDS822 IC requires a 3V power supply. As per the TIA-EIA-644 standards, All LVDS outputs have a ±350mV swing and an offset of around 1.2V, which is supported by this device .
slla038b.pdf
The RGB display is supported, as the…
