Part Number: DS90LV028A
Hi,
Let me discuss about DS90LV028A IOH spec. Customer want to know the DS90LV028A drive capability for other devices to be connected. Could you tell me IOH(max) current?
Best Regards,
Yusuke/Japan Disty
Part Number: AMC1035-Q1 Other Parts Discussed in Thread: AMC1035 , ISO7740 , DS90LV027A , DS90LV028A , AMC1210 , AMC1336 Hello,
in the datasheet of AMC1035 is written: " The modulator bitstream on the DOUT pin changes with the rising edge of the clock signal…
The average data rate does not matter; what is the SPI clock frequency?
Just using single-ended signals with buffers (e.g., SN74LVC125A, SN74HCS125) at both ends is possible. But if you expect a noisy environment or a ground shift between the two boards…
A serializer combines many slow channels into one fast channel.
To transmit a single channel, what you want is just a transmitter and a receiver, e.g., DS90LV011A and DS90LV012A/DS90LT012A.
What protocol are you going to use with your microcontroller…
The THVD2450 and THVD2450V are different devices.
For unidirectional signals, you do not need a termination resistor at the driver, so the load is lower.
But to reduce power consumption for distances less than 10 m, do not use RS-422 but LVDS. Use drivers…
Other Parts Discussed in Thread: DS90LV028A Hello, all
Now we have one inquiry from our customer, who would like to use DS90LV028A to transmit LVTTL signal into Altera Cyclone4. (2 LVTTL outputs are required on this case)
The input signal from Optical communication…
Hi Ishiwata-san,
The section of teh datasheet you are referring to only references the input of DS90LV028A receiver device. DS90LV028A input is differential not single ended, LVDS differential receivers typically have built in fail safe for the open condition…
Hi Axel,
You may find this document useful on learning LVDS however both devices will need external 100 ohm termination. SN65LVELT23 does have two channels. I recommend using DS90LV012A (single) or DS90LV028A (dual).
https://www.ti.com/lit/ug/snla187/snla187…
