Part Number: F28M36H33B2 Tool/software: We used F28M36 for a design, but during the debugging process, several chips experienced a situation where the M core crashed and the C core was normal after running for a period of time. We did not use a watchdog…
Part Number: F28M36H33B2 Hi C2K champs,
A bus or hard fault occurs with a very low occurrence on a read RAM access on a F28M36 device – the problem happens on a read access in the LRAM3 area (From 0x20018000 to 0x2002FFFF) / no specific RAM address…
Part Number: F28M36H33B2 I just wanted to post the solution to my post with the reset problem but the thread was locked.
We finally managed to figure out that the problem was caused by the 3.3V voltage regulator startup time. For this specific batch…
Part Number: F28M36H33B2 I have a board with the Concerto F28M36 on. I have been using this board for a few years. I recently got a new batch of the boards build up and now I am unable to get the device running. After some investigation I noticed that…
Part Number: F28M36H33B2 Hello Team,
Currently, my customer is planning to use F28M36H33B2 which has on its input an optocoupler. The Forward current of the optocoupler is like 25mA to 50mA and is written in the datasheets that the controller that the…
Part Number: F28M36H33B2 Other Parts Discussed in Thread: CONTROLSUITE I had a project that was working fine on my Concerto Board. The project was written in C and I just made a few changes to port it to C++. The program compiled successfully and I then…
Part Number: F28M36H33B2 Other Parts Discussed in Thread: C2000WARE , CONTROLSUITE Dear team:
A customer of mine needs to use the ePWM synchronization function. He wants to know how to set the GPIO port to SYNCI? Are there routines that include this…
Part Number: F28M36H33B2 Other Parts Discussed in Thread: CONTROLSUITE , F28M36P53C2 I am trying to get my Gui Composer application to connect with USB-UART. I have added the serial monitor code to my target, (M3 core of the Concerto) and added the USB…
Part Number: F28M36H33B2 I am trying to setup a Gui composer app that uses one of the Network communication models ( IBM IOT, MQTT or HTTP ). But I am not sure how to setup my target application in order to get this working. I suppose I need some MQTT…
Part Number: F28M36H33B2 Other Parts Discussed in Thread: CONTROLSUITE
I need some help to setup a Gui composer app that uses one of the Network communication models ( IBM IOT, MQTT or HTTP ). I am following the GUI Composer 2 User's Guide ( https:…
