Part Number: UCD90910 I have programmed several of the same board that uses UCD90910 with the same fan profile and successfully stored RAM to flash for all of them. Boards are then installed into our systems, and fan speeds are checked using the GUI.…
Part Number: FUSION_DIGITAL_POWER_DESIGNER Other Parts Discussed in Thread: UCD9222 , TMDSEMU200-U Hi ,
I saw from description FUSION DIGITAL POWER DESIGNER support for UCD9220 — 2MHz, 2 rail, 4 phase digital PWM buck controller.
Could help me to…
We're have a PC that is connected to 2 target with 2 different PMBus where I have connected using two TI USB Adapters. Went through doc of the command line "FusionConfigWriter.exe", "FusionParamReader.exe", "FausionParamWrite.exe", there is no mentioned…
Part Number: UCD90160A Hi ,
I have an engineer that is trying to program the shut-down sequencing on the UCD90160A (the power up looks good), but all the rails seem to be coming down a the same time.
Both radio button is selected, so this is showing…
Yes, the SMBus & SAA Tool allows you to communicate to any I 2C or PMBus device. The tool can be launched from either:
• Fusion Digital Power Designer GUI (Tools → SMBus & SAA Tool)
• Fusion Digital Power Designer → Tools → SMBus & I2C & SAA Debug…
Part Number: UCD9246 HI,
I am doing some testing on UCD9246 based power supply. When I chnage the switching frequency in GUI, the GUI is crashing and showing Fatal Error. I tried to change the frequency when all rails are in OFF condition. Is there…
Part Number: DLP3010EVM-LC Other Parts Discussed in Thread: DLPA2005 , DLP3010 , DLPC3478 , DLP3010LC
Hi,
I'm testing DLP3010EVM-LC with custom optical engine.
It works well when I tested it using the display menu.
However, while testing the internal…
Hi BatMan,
I am looking into the recognition issue with Fusion-Production-GUI available here: FUSION-PRODUCTION-GUI Software programming tool | TI.com
Getting back to you with a solution as soon as possible.
Regards,
Soumya
Part Number: UCD3138 Dear UCD friends,
I'd like to use single UCD3138 to control 2 HSFB power supplies, and hope the fusion GUI can be used to monitor those 2 power supplies data.
I see the fusion gui will display page 0 at default, can you please…
Part Number: TPS40422 For TPS40422, In Fusion GUI, XML files needs to be converted to CSV files. Could you please share the procedure for the same? Is there any method to do the conversion offline?
TPS40422
