The Fusion Digital Power Designer SW can be found here:
www.ti.com/.../fusion_digital_power_designer digital power designer&tisearch=Search-EN-Everything
You will also need the USB-to-GPIO adapter to connect a Windows PC to the PMBus interface connecting…
Hi Mathew,
Please get datasheet for following questions.
1. Is SMBUS of TPS53622A( VR13 regulators) can connect with CPLD to monitor Telemetry reading and Other programmable configuration setting?
Yes.
2. Do we have any sample code for SW configuration…
Part Number: TPS546C20A [Test environment] 1. We purchased "TPS546C20AEVM1-746" to use "PS546C20A".
2. We have successfully tested VOUT from 0.35V to 1.6V in the following environment. "TPS546C20AEVM1-746" - (USB-TO-GPIO) - "PC (FUSION_DIGITAL_POWER_DESIGNER…
UCD90xxx device supports ACPI(up to 8 states).
TI does have the EVM to support UCD9090A. The schematics is also available to download
http://www.ti.com/tool/UCD90SEQ48EVM-560?keyMatch=UCD90SEQ48EVM
As for the sample project, please download fusin…
UCD90160A can be programmed as long as your board has a I2C interface. You can order http://www.ti.com/tool/usb-to-gpio and connect the ribbon to your prototype board.
Download http://www.ti.com/tool/FUSION_DIGITAL_POWER_DESIGNER software, so that you…
This is a wrong GUI. Fusion Digital Power Designer GUI can be downloaded from the below page:
www.ti.com/.../fusion_digital_power_designer
Connect the adapter to computer, do not attach any device to the adapter, launch the Fusion Digital Power Designer…
hi
I can also describe the use of I,the xilinx KC705 SchematicsEVM,UCD9248 Address 52 use 1.0 V to 1.0 V to 3.3 V to adj V,
The design of the I didn't use adj V,I'm fusion_digital_power_designer closed 2.5 V and export XML file,Address 53 also changed…
HI,
Looking at http://www.ti.com/tool/fusion_digital_power_designer I dont see any platform requirements listed for the package.
Are there any? Does this run on MS Windows 10 OK?
Thanks, T
Hi,
It looks to me there is some kind of fault after 1st turn on event, and then turn on again with hiccup. You can connect TI Fusion GUI to the controller and monitor what fault has happened. You can download the GUI from www.ti.com/.../fusion_digital_power_designer…
Please download Fusion Digital Power Designer GUI from the web page below:
Please make sure the Fusion GUI can detect USB adapter.
Please make sure each PMBus slave device has a unique address. You can disable all other PMBus slaves to isolate…
